Wind board - decorate the roof of a practical use

timber for the roof - with which we are dealing?

Wind board is operable to prevent the intensive blowing attic, there is the creation of a balanced temperature, as well as giving an aesthetic appearance of the roof overhang.For the manufacture of wind boards is not only a tree but also metal, and polymeric materials.

Self installing wind boards, typically, is not difficult, but it is better to invite professionals who correctly will remove all the sizes and establish wind board without damaging the roof.

on the market presented various options for the wind boards, different color, size, material, texture.There are even options for decorative, decorated with carving or drawing such strips and roof give the house a unique, personalized and well-groomed appearance.

Wood has always held in high esteem

wood trim - the oldest and well-known way to finish the eaves.Board for filing is available to companies that manufacture joinery. timber for the roof - it's wood, dividing into groups the method of cutting.

This type of building material, have long been used in many areas of construction, becomes particularly relevant at the moment, thanks to its environmental qualities.To protect the wood from rot and bugs, as well as to make it fire-resistant qualities of the raw material is processed a large number of special tools.

used Edged board arbitrary length and width of about 25 mm to Binder eaves.In order to protect eaves, usually used pine boards, spruce and larch.The latter are more expensive, but more durable.These boards have different ends: profiled tongue and groove, direct or by cuttings.

they are mounted back to back and the gap between them remains, then additional ventilation holes do not need to make the case of direct ends.If boards have perforated edges or attached overlapping, it is necessary to make the ventilation slits and attach them to the grid.The distance between the two mountings of the board should not exceed 100 cm.

Wooden filing overhang requires constant monitoring over the state.Approximately every 5 years should be treated with protective agents against fungus and rot, as well as to carry out biosecurity, following the implementation of impregnation wind board stained or varnished reveal.

Wind board - the principle of fixing

in construction norms is nowhere stated that roof overhangs must-sew.You can do without it, but if the design of the roof rafters and subtle at the same time can see the bottom of the binder made, such overhangs, it is desirable to sew.It betrays the aesthetic appearance of the structure and protect the attic space of the temperature and the appearance of birds.

Attach wind board are two ways .The first - the elements of the binder attached directly to the roof system, the second - at right angles to the wall of the building, ieat right angles.

Before starting the installation box for filing insulate the walls, this is especially true for horizontal cladding.Also, after the installation of the roof is necessary to make trimming the ends of rafters extending beyond the facade.This must be done on the same line and parallel to the walls of the building.

To box installation process and the most skin need to use scaffolding or a ladder, screwdriver, screws, saw, pencil and tape measure.

For manufacturing cladding box using thick board or beam.One edge of the board is attached to the bottom of the rafters, and the second - to a previously lowered and secured with the help of signal bars more board located against the wall.

on design corners, where two converging roof slope, the board did not put on an edge, and Lay flat becausethere will be a joint, and will need to attach the two ends of the boards.Butt joint must exactly run from corner to corner of the roof walls.This method of attachment allows the boards to obtain a rigid structure box, independent of the walls of the building.