Drainage system with their own hands

Methods of designing drainage systems

If you plan to make your own hands drainage system was made from scrap materials, you must at least carefully adhere to the technology of designing such systems.In particular, pay attention to such moments, the construction of drainage:

• trench must be dug to a width of 0.5 meters around the size of your building.It should also have a span of 2-5 meters from the ground on the depression which is equal to the level of the foundations of the sole.
• necessary to calculate the lowest and the highest point on your site.
• sure to calculate the slope drains, which should be 2-3 cm.
• Find a special place for the rejection of moisture from your yard.

Regardless of the method of designing and installing a drainage system, have to use the classic construction materials in addition to improvised.In particular, the need to prepare:

• Sand
• The fine gravel
• Major gravel, which is more than 0.5 centimeters
• Soil

most common types of structures:

• design, which is located in a triangular form, Thereforeanother - a slab of concrete.

It is necessary to remember that the drainage system in the operation can be compacted.To avoid such strain, it is necessary to lay concrete pipes upstairs.Then you will not have unnecessary problems in the future operation and design of drains.

• construction can spread perforated and pre-treated asidolom boards.If you have problems, you can use large stones.
• design can be made of boards, and its channel will be surrounded by cushioning a large gravel.
• can also use fascines - is a bunch of germs.Sprouts can be used with all kinds of trees, the main thing that would be attended by both large and thin branches.

desirable finer branches pledge to the side, where the water will be sent to the drain.It is better to design a building on the grounds of a nearby ditch.No need to clean out of sight of the fact that the width of the bundles of sprouts should be at least 25 centimeters.

• order that would drain the bottom took a free current, which removes all moisture is constructed from bars goats.
• Good drainage may cause asbestos-cement pipe is perforated.
• Very often use ceramic pipes, they also do an excellent job with their task.

Methods of designing

drainage system to the drainage system with their own hands last longer need to use a recommended drain pipes.To establish such a drainage system needs to be done, such processes:

• The first thing to do - is to dig a trench depth of 20 centimeters.If your soil gliny- of 60 centimeters, and if sandy bottom - 110 centimeters.
• To water after the rain flowed quickly flooded and not necessarily in the trench should be a certain lattice.
• necessary to correctly calculate the deviation, it is necessary that he descended to the lowest portion of the side.
• Choose place drainage.
• Trench bottom is filled with gravel about 25 centimeters.
• most important process - this inversion geotextiles drainage pipes.
• as backfill material most commonly used sand or gravel.

Process Specification Mounting drains

systems installation features on this site:

• preparatory process of the drainage system to a depth of 1 meter, width - 0.5 meters.
• must be observed bias.
• Proper filling the trench.

At that point, if you do not have a reserve drain, comes to the rescue drain well.For the design and installation of drainage systems own a lot of effort and cost will not be.It is only if you have not a large plot.But if the object requires the installation of pumping stations and drainage system needs to be more complex, then without the help of a specialist design and site plan you can not do.