How putty wall under the wallpaper

necessary materials and tools

1. Caulking
2. Spatula
3. Sandpaper Primer
5. Rollers

Preparations

Before gluing the wall to prepare new wallpaper, you must remove the old.To do this, the foam of cushion moisten with warm water, and then treat the wall upward.Since water is quickly absorbed into the walls and dries immediately wet the wall is not necessary.After the material is saturated with moisture, they are easy to remove with a spatula, if you start at the bottom and pull the fabric up.With insufficient moisture wallpaper should conduct a wet roller again.Repeat this step until the wall should not be cleared of old wallpaper.

Then the surface of the wall must be primed using a primer solution which is able to penetrate deep into the wall, leave the soil surface to dry completely.Then you need to get rid of bumps and holes - if they need to seal the plaster, remove the excess with a spatula the mixture, align and allow to dry.Thereafter, the surface was treated with an emery paper and cleaned from dust.Places repair primed and allowed to completely dry the solution.

Plastered walls under the wallpaper

Decorating the walls carried out in two or three layers, considering the type of the selected wallpaper for pasting premises.To do this, prepare a plaster according to the instructions that came with it.Work should start from the ceiling to the floor, that is, from top to bottom.

Using a spatula, a width of 150 mm should apply the mixture to the other spatula 300 mm wide, which will be carried out and finishing.The tool with a mixture must be applied to the surface of the wall and hold the left side to the right, evenly distributing the filler.To remove excess material, it is necessary to hold the spatula in the reverse direction.Each new layer of putty to be overlapped on the previous five centimeters.

most embarrassing job cuts - finishing bottom of the walls.To do this, apply a layer of putty on a spatula, to sit down and attach it to the junction of the wall and the floor, holding the tool up.Similarly, the action is removed excess weight filler.Perform the alignment surfaces must be thoroughly without missing wall sections.

After plastered walls need to give the mixture to dry, after which the surface is leveled with sandpaper.After cleaning and priming the walls start to finish applying the second coat of plaster.Work is performed similarly to the above instructions.

In the event that the selected room for pasting wallpaper thin layer, for example, vinyl or silk-screen printing, wall necessarily shpaklyuyut third layer finish.After completion of the work it is important to achieve maximum surface smoothness.

When finishing the walls completed, you need to cover them with a primer and allow to dry - this will exactly go to wallpaper and glued well, prevent the formation of mildew.