How to plant filler - Teach all the tricks

How to dilute putty?

fillers there is really a lot, because this finishing material can be used for walls, ceilings and even the facade, and in all cases it can be a different composition.You also need to know for a stage finish is powder, as well dilute putty without this information it will be difficult.On the latter criterion distinguish, for example, starting and finishing putty.

As dilute putty, usually indicated on the label.Although it is possible to take a chance to make their own adjustments, if you need her to have some more pronounced properties.Sometimes it is required for decorative (textured) or special (waterproof, acid-resistant) filler.In order not to impair the quality of the finish, it is necessary to know the general principles of cultivation of plastering materials.

How to dissolve dry plaster - basic rules

Read the instructions carefully, you will find there the proportions in which to mix the mixture with water.Take a container of appropriate size, which will be easy to get in the way, and to pour the contents of the package.Add the right amount of water and begin to knead, the best thing to do is

mixer for 10 minutes .The water should be clean and not cold, it is best at room temperature.

Then you can start finishing as dilute putty dry, you have seen, it is not difficult.To work with this material can be about 40 minutes , until the mixture begins to thicken and stiffen, and by going through this time threshold setting will take place almost on sight.Of course, the average time, better verify this fact in the instruction on the package, and this may affect the shelf life and room temperature, and the quality of the material.

extend the viscosity of putty redissolving impossible better mix a new solution, a pre-clean cleanse container.Because the quality of finish will suffer greatly.

If putty is necessary in several layers, you must wait for all good has evaporated, but do not desiccate, that is, the second layer can not be put on the following day.You also can not be dried in an accelerated program, such as a hairdryer, this will lead to cracking.Do not apply to poorly dried up putty other materials, such as soil.

How to dilute putty - especially

It has been said that this decoration material is of several types, and therefore is to clarify some of the nuances, as a filler plant, depending on its purpose.We begin with the starting , which is used for the shell construction.Its consistency should not be very fluid as it is applied with a thick layer and hides the rough surface defects.Sometimes this layer should be about 5 cm, it is possible to apply only a few techniques.For during this time the solution has started to set, the time of his life artificially prolong the addition of river sand.Be sure to remove any impurities, that is, clean it well and mix in a ratio of 1: 1.

the Finish filler prepared according to instructions if it is sold in dry form.But now it is becoming increasingly popular LP liquid finishing putty.It is diluted with water is not necessary, it is ready to use right out of the package, usually is sold in a plastic bucket.Moreover, it is possible to open a few times, it does not lose its quality.A special feature is the existence of finishing putty facade and interior of the brand, facade is often toxic, which is unacceptable for interior work.Pay attention to it.