How to connect to the sewer bath

Preparatory installation work

installation work should include the following parameters:

1. Connection and installation of drainage networks, should be executed with the help of certain siphons for bathtubs.
2. Use corrugated pipes is not advisable, as they are characterized by defects such as rapid accumulation of micropollutants, flow resistance is very high, as well as is not difficult to clean.
3. It is important to remember that the height difference between the drain pipe and connect the point to be made correctly.
4. The interior of the siphon has a property very often clogged, and in order to do the cleaning, we must place it in an easily accessible place for us

Selection pipelines

In order to know how to connect the tubsewerage, and you can pick up a good quality pipe.Most often such compounds used plastic pipes, thanks to their advantages:

1. to connect the unit to overflow grids is better to use a compound that consists of two tribes and has required us to turn downhill.
2. first option considered very complicated connections, and not all of it out, so you can use the corrugated material.

selection pipes for connection of drainage networks occurs so:

1. siphon fitting occurs via a pipe with a diameter of 40 millimeters, only if Drainage network consists of plastic pipes.
2. If we have a sewer pipe with a diameter of about 50 millimeters, it is necessary to attach an adapter, you can use it to make the transition from 40 millimeters to 50 millimeters.
3. You can use a rubber sleeve with a size 73/40, but only if the sewerage system is made of cast-iron pipes.

basic rules baths connection

First you need to follow these methods:

• necessary using the instructions correctly and accurately assemble the siphon.
• All elements consisting of plastic, collected his own, without the aid of any tools, since they can damage the part.
• When done properly, a portion of the tube is attached to the collected contact elements, and the other to the sink drain.
• To all compound were sealed, have to do quality installation work.

If at the time of installation work, found any flaws or leakage, they immediately need to remodel, or more precisely to eliminate.Since the future use of the installation need to be replaced very important elements.

connection to the water supply network

To connect the bath to the water supply network, you need to know a couple of key processes such as:

1. order to quickly make repairs mixer, you must install a special shut-off valve to the clutch.
2. couplings, which are located on the mixer should have a connection to the eccentric, to connect the need to use special tape.
3. We must not forget to put the data in the complete sprinkler on the eccentric.
4. mixer to be inserted inside the gasket, or they can be silicone or rubber.Thereafter the mixer can be installed.
   

   When a compilation of specific schemes for the connection setup, you can enter it and check quality performance of this work.As you can see all sorts of leaks in appliances and for this will need to change the pad.It is possible that this problem has arisen due to non-quality gaskets.

5. mixer Binding should be done from two sides, which have gaskets at the same time.
6. When purchasing a bath, it can be equipped with mixers have, for such an option, adopt such rules:
   • permissible height must be below the level of installation and mounting place reinforced hoses.
   • End of the pipeline can not equalize, through these hoses.
   • The main thing that the hose had greater length than the span between the installation and the pipe

   .