Build Daily

Equipment

August 12, 2017 18:06

In the washing machine powder remains : why the powder in the tray is not washed off and the machine does not take it , what to do

click fraud protection
the washing machine is in powder
  • What check?
  • Typical failure
  • causes and what to do?
  • Tips

When the washing machine is working properly, the result of washing becomes clean and fresh linen.However, after some time you use the appliance housewife might notice that after washing in the drum are badly stretched, smelling of damp things.If this happens, it is necessary, primarily, to check the detergent supply container.When a normally operating the washing machine it is empty, but if there was a breakdown in the feeder will be a big part of the detergent.

This problem is quite common.On why washing powder remains in the machine and what steps you should take to fix it, read this article.

Laundry detergent is poured into washing machine

What check?

In order to properly diagnose the problem, you need to conduct a thorough check.Try to find out the following points:

  • Is Gaining washing machine water washing after the program?To find it, you need to run the wash mode (you can do it with an empty drum).
  • Do water pipes are blocked?Perhaps, the water supply is difficult due to not fully open the valve.
  • there enough strong water pressure in the pipes?If a low pressure in the tubes, the water will gain considerably more slowly than usual.
  • Whether container filled compartment proper detergent?In some models of washing machines is provided for the separation of the powder, which is activated only when running a prewash program.
  • Do blockage formed in the dispenser of washing powder?Sometimes water flows freely into the feeder, but the detergent can not penetrate into the hose due to the fact that it is clogged.
  • observing whether the dose of washing powder?If you use a larger amount of washing powder than is recommended by the manufacturer, the surplus can not climb and remain in the container.
  • Do you use instead of high-quality counterfeit washing powder?low quality product can stick together, coming into contact with water, and does not leach out of the feeder.

about how to recognize a counterfeit washing powder, see the transmission channel "Examination of things. OTC".

Typical failure

  • Problems with the misuse of detergent.If household chemicals, used for washing, is poorly soluble in water, it can cause the formation of blockages in the feeder washing powder or a hose through which the detergent comes into the drum.Household chemicals can be hammered into the various elements of the washing machine and if it is poured into the container too much.
  • Problems with the water supply. If the washing machine is not taking on water or does so too slowly, detergent can be washed out of the feeder is not completely.The reason for interruption of the water supply are usually the water pipes.The case may be a weak pressure, the formed blockages or closure valve.
  • Problems with zabivshimisya nozzles. hoses and nozzles through which water and detergent are moved inside the washing machine may clog the remnants of detergent, dirt or small objects.In this case, the detergent supply may be stopped.

causes and what to do?

Cause

What can be done?

problem in washing powder

Use only approved detergent from a reliable manufacturer;strictly follow the dosage;each time after washing rinse the feeder washing powder

problem

water pipes Check that the water in the washing machine, if the water inlet valves are closed flows;upon detection of clogging in the pipes remove it using a flexible cable or special equipment;make sure the water in the water pipes is a good pressure

problem of clogged nozzles

Most often clogged nozzle, by which detergent enters the drum;to clean it, remove the front panel stiralki, loosen the clamp and remove it gently, then rinse under running water

about what to do if the washing machine does not fill with water or bad washes washing powder, see the followingvideo.

Tips

If detergent, covered container, remain completely dry, then water in the feeder does not arrive.If the water is set as usual, damage can be serious.The correct solution is to seek professional help, as will probably require replacement of some parts.

instagram viewer