Today vinyl wallpaper gained impressive popularity.In some countries they are simply pushed many other popular types of wallpaper.There is no doubt that the vinyl material has a number of positive features.This type of wallpaper is much more scratch-resistant than conventional counterparts.Also, the vinyl material has a luxurious appearance.On sale you can find dozens of different patterns that can not be compared with patterns on classic wallpaper.In fact, sticking vinyl material - a fairly simple process, but you need to know some of its features, without which the best results have not been achieved.

Features vinyl wallpaper

necessary to know that the vinyl material is relativelyspecific.When wet, these wallpapers are stretched significantly, and in the process of drying vinyl begins to narrow.Thus, the need to closely monitor the process wallpapering to eventually strip of material formed one component of a decorative room.

also need to give serious consideration to the choice of colors and materials.Many people know that the sale can be found most often it is light and bright color compositions.Clearly, such options are not always suitable for particular interior room.

main aspects of the preparatory work

Before you start gluing vinyl wallpaper need to take care of a number of important points.Without them, the basic process can go quite as planned.

At the beginning purchased wallpaper checked for defects.Unfortunately, with such a nuisance buyers face very often.Some stores sellers simply want to get rid of defective rolls.Even the difference between the color compositions rolls of wallpaper can be considered a marriage.It is possible that differences in color - it's just a different composition, but in this case, the rolls are different names and codes.

After unpacking the need to explore all the badges and marks on the insert information.It should be borne in mind that the information on all rolls should coincide.Also inserts will be indicated, as the it gluing vinyl wallpaper particular brand, if you need to match the figure at the glueing.It should be noted that to simplify the process of gluing is better to use wallpaper that do not require docking.In this case, the pattern need not select to receive the full composition.

Often people buy 2 different types of wallpaper, so that when glueing to alternate different stripes.With the right choice of material in the end it turns out really worthy composition.

on the insert information about the preparation of the wall surface must also be specified.In some cases, there are special requirements, without which you can not quite get the expected result.

Before the glue, it is desirable to measure everything correctly, so as not to cut individual pieces of wallpaper are already in the process of finishing the walls.

For wallpapering spatula handy wallpaper, with which you can easily smooth out all the bumps and blisters.It is said that during the process itself takes a few times to use a wallpaper scraper, as the air can penetrate under the fabric for about two hours until the wallpaper is still dry.

is important to understand that the area must be dry and warm, or wallpaper can be deformed during drying.Also during the main process can not tolerate large fluctuations in temperature.Thus, the need to control the optimum temperature, given that the extreme cold and heat spoil the vinyl material.

In addition, all electrical equipment must be turned off before the process wallpapering.If you choose to remove all the sockets, you must use a shield and turn off electricity at the apartment.

basic process of gluing vinyl wallpaper

begins the process of gluing vinyl wallpaper from the corner of the room and performed overlapping the adjacent wall (5 mm).After that, the overlap can be removed with a knife stationery.If sticking occurs butt, be sure to start with the angle, otherwise the desired result can not reach.

If you want pokleit wallpaper the ceiling, you need to start the process from the windows.Also, this procedure assumes that work together as one to cope with the tasks too difficult.The first person is engaged priglazhivaniem one part of the material, and the second holds the rest of the material using a mop.

wallpaper stuck to quality, you need to take care of the uniform application of the adhesive.To do so, enclose under the edge of the material sheet of disposable paper.This will safely apply the adhesive in any volume.If for some reason some of the corners of the wallpaper come unstuck should just turn away a small portion of the material and re-apply the adhesive.

adhesive is applied uniformly throughout the perimeter of the strip.Then you need to lay down the wallpaper twice.One-third of the top of the strip is folded up the middle, just like the lower part.Within minutes, the material should lie in this form.This will thoroughly soak the wallpaper glue.

Next wallpaper deployed and applied to the wall.With the help of wallpaper trowel smoothed the entire band, and from the middle to the edges.Traces of glue are removed with a damp sponge.In order to get rid of the excess wallpaper at the joints, you can use a metal ruler and stationery knife.Care should be taken not to cut the desired part of the material.

If necessary sticking borders, it is necessary to purchase also a special glue.If vinyl wallpaper relief, borders can not stick to them, so during wallpapering need to create a small indentation.In

if after smoothing one strip of wallpaper slightly went for another, it should again flatten the strip by applying a force to the side opposite to the defect.It is likely that the joints between the stripes will be ideal.Once dry, glue the wallpaper will be a little longer.