How to hang wallpaper on drywall - preparation , tips and tricks

Necessary preparation for gluing drywall

wallpaper In some repair manuals can be found the assertion that only need to seal the joints after installation of plasterboard, drywall and wallpaper can be closed.We will not argue - it is.And let's say more - you can not even be primed drywall, finishing material and without additional impregnation lie, that is - tightly.However, loom more trouble in the future.First, if you use bright wallpaper, it is likely that drywall will shine through.Second, if you want to later change the design (and sooner or later, such a desire appears), then pull out the old wallpaper off the wall will only together with a top layer HA-sheet - cardboard, and so you will destroy the wall.Therefore we recommend not to go on about the short-term benefits, and do everything by the rules.

1. After finishing installation of the FCL, the entire area of ​​the walls, or prime with conventional antifungal (if the room humidity expected) primer using a wide brush.

2. All joints, including the corners, apply serpyanku.This is such a mesh material in a roll-like bandage.Material self-adhesive, but it is better to put on additional PVA.

3. The joints, and along the entire surface of GC sheets must be carefully proshpaklevat thin layer starting filler, and after drying - the finish.

4. Possible irregularities gently abrade a special mesh or sandpaper with fine abrasive - grade 80 or 100. But not too zealous, that did not shine through drywall.If this happens, you need to putty again.

5. After the spackling before drywall covered with wallpaper to remove all dust from the walls and provide quality adhesion, you must all primed again.Instead, you can use wallpaper paste, in the instructions for use which certainly indicates what proportion of breeding for priming.If for some reason it is impossible to make this step, you need to at least wipe the walls with a damp cloth or sponge, "tying" motes.

How to apply wallpaper on drywall

correct Wallpapering on gypsum board based on the same principles as in conventional wall.And, as a rule, it is even easier to do, because the evenness of the wall is close to the ideal.Visually it helps to see how the Wallpapering video drywall.

view wallpaper choose according to their own preferences - you can use any - from paper to a non-woven, silk screen printing, etc. To all the spoil, it is necessary to know what is the difference between how pokleit wallpaper on drywall or plaster...

Tips: How to glue different wallpaper on drywall

• First of all, from the work with the help of the long line-level spend pencil exactly vertical lines of windows on either side.
• Calculate how many entire fringes falls on every wall, helps roulette.
• is important to accurately horizontally ustarovit front page.Especially - if the wallpaper have a clear picture.In this case, the slightest deviation will result in a skewed pattern throughout the room, and it is fraught with the fact that all repairs will come to nothing.All further strips are butt, and it's pretty easy process, when compared to the stucco walls.Because the FCL are perfectly flat surface, and properly enough pokleit the front page, and then - just combine the joints and, of course - drawing, if any.
• Do not forget to give the wallpaper on paper a few minutes to impregnate after spreading glue.It is desirable that all the impregnation bars were identical.
• When using non-woven wallpaper glue smeared on the wall only.
• Remember right after forcing air out of the wallpaper glue to wipe the next ledge.
• It is advisable to use special rollers for wallpapers and iron joints of special - small and tough.

We hope that by using our tips and tricks, you will experience the repair quickly and will long enjoy the works of their hands.