Technology plaster the walls with his own hands , or how to do everything with the mind

Tools

• spreader that can be quite different, depending on their intended use.Available in all kinds of width and length.Looking for application and leveling of the solution, as well as ready-mix plaster trowels;
• Shoulder plaster, which is used to pour, mix the solution.Also it is used for leveling and cutting solution;
• Special ladle about 1 liter capacity, designed for finishing work.It is used for the most accurate dosing solutions for application of the material onto the surface;
• Lighthouses are needed in order to properly and accurately mark the level of the future plaster;
• rules, which are a kind of aluminum slats of different dimensions and lengths.They are used to align the solution beacons, drawing eaves, finishing slopes.

field of all associated tools have been prepared, the right wall of plaster is required to include surface preparation.It is necessary to lay down a layer of plaster evenly and for a long time was fixed on the wall.

Preparation

first surface by cleaning the surface from dust, dirt, old paint, bitumen and grease.This grease stains and bitumen deposits are removed manually by mechanical means.Also made the surface moisture.

If the surface is too smooth, it creates a small roughness for better adhesion of the solution.On wood or cinder block walls is applied notches, which they cover or netting armosetkoy with a mesh size of not more than 5 cm. On the brick walls can be a little to expand the seams to a depth of approximately 1 cm.

Using thin strips define a plane proposed works.They serve as a kind of straps.On the floor is laid polyethylene film to the incident from the surface of the mixture is not soiled floor.

walls

plaster technique completed the preparatory work proceed to the very plaster walls. Apply it is by spreading or spraying. to last method is first to get used to, so it requires some practice.

Prepare the solution for plaster.The mixture was diluted with water according to the instructions on the package. most commonly used cement-sand mixture in the ratio of 1: 3 .If you get too liquid solution it is necessary to omit it dry brick.Just a few minutes a brick takes all the excess moisture.

the corners of the walls on the estimated thickness of the planned plaster mortar made of the brand.These brands usually puts and begin to apply the solution (throw) in the space between them and the wall.Having one such beacon on the one hand, begin to do another with the following aspects of this same angle.

In the next stage of work doing exactly the same beacons at an interval of about 1 meter, but the entire height of the wall.The space between the lighthouses also thrown solution.Once the alignment is carried out using a trowel or rule.Their edges are located at the nearest beacons.

In the final stage, after a few hours, is smoothing plaster.To carry out this process is necessary when the plaster has not yet solidified, but not in the liquid-viscous state.For grouting use a grater, which is tightly pressed against the wall, and in a circular motion clockwise produce work.The pressure should be performed with different force depending on the irregularities.Where depression - is weaker, where mounds - stronger.

course that best illustrates the process for a special form of a roller.Technology wall plaster, the video for a proper understanding of which you can see on our web site online, is easy.