Connection to the sewer sink in all possible ways

Preparations with sink

1. Altitude.Standard sink placed at a distance of 85 cm from the floor.This height corresponds to the horizontal line on which are located the device bathrooms.If the sink has a support leg or a table, fixing the height can not be installed, as will the very foot of the most defining high.
2. Marking mounting on walls.Connection to the sewer sink also requires marking fasteners before installation.In marked space fasteners are placed for cleaning the bowl.To mark the sink adjusts to the surface and the level of mark its location.To simplify the job is to perform it alone.Thus, your assistant will hold the sink, and you try to mark the place where it is fastened.The support leg or rack greatly simplifies mounting, since they favor the support during installation.

process of installing fixtures.It occurs in several steps:

• Drilling holes in the wall at the marked point;
• Clogging dowels;
• Screwing mounting studs.

are notorious for installing sinks in the kitchen and the bathroom can not do without plugs and pins, inserts made of plastic, which are important in the installation, and therefore are supplied.

It is important to note that during the screwing studs screwing depth should be such that enough to spin the mounting nuts and hanging them on the sink.Since the projecting portion pin should be to be up to 1.5 cm more than the shell thickness to allow properly fasten the nut.

Water connection

mixer is recommended to set before the shell will be placed and connected to the wall, but also nothing bad will happen if you make installation directly attached to the sink.

To set a defined order:

1. mounting studs depending on the species screwed into the mixer.
2. sink mounted on the pipe hot and cold water, and after minimal effort tighten them with a spanner so that it was not necessary to tighten them firmly.
3. According to the scheme used shell connection hoses, through which water is supplied from the hole in the cup.
4. on the back of mounting pins secure the sealing elastic washer, and then pressed against the retaining nuts.
5. wrench to tighten the fixing nut.

spout mixer should be at an angle of 90 ° to the wall and the sink.

Mounting sinks

fixing process stages is as follows:

1. room sink with mixer on mounting studs.
2. Putting plastic liners.
3. Tightening the nuts.

If there is a support column or table, then install them in the first place, as a support.

hose hot and cold water

nut and valve need to keep using pads, but too tight to tighten the nut is not necessary.The rubber gasket is used, so as not to burst a possible place of water leakage after its incorporation.

Easy connection to the sewer sink

If water is already connected, the next step should be to connect the drain.The first thing that should be used - a siphon.

siphons come in two forms: by the letter S and bottle-shaped.If he has a special hole overflow protection, then siphon For more pipe for water overflow.is S-shaped, because the bottle shape leads to rapid clogging sewage For kitchens the most successful.

If sequentially, the entire installation process takes place in the following sequence:

1. The sink should be placed trap release, and then attach them to each other.
2. To siphon body bolted rigid or corrugated pipe.
3. Prepared tube is placed in a sewer hole.If the diameter is greater than the release pipe can apply a sealing rubber sleeve, which will be an adapter between them and fasten communication.
4. All connections should be checked for leaks and damage.

Important requirements prior to the

• not worth too much to pull all the key communications as a connection to the sewer sink can damage the rubber seal and prevent leaks.
• If water leakage has been detected between the cuff and the water drain must be: remove the cuff to dry parts, then lubricate the sleeve sealant and connect together all the components again.
• If you connect a double sink, you should buy a siphon tube into two specially

Each owner can easily follow the proposed rules and quickly install the kitchen and the bathroom sink to the sewage system, water supply, and even attached to the wall by their own efforts.