How to choose the correct heated towel rail for the bathroom ?

Water heated towel rail for the bathroom -

popular solution Entering the new buildings, the young family or the lucky ones in the bathroom is usually exhibit typical coil embedded in the hot water pipe.That's just have the water heated towel rail for the bathroom, with his own hands such a system, however, it is difficult to deliver, if not prepared pipe. The benefits of this design a considerable, it is by passing through the hot water itself, emits a certain amount of heat due to turns.The latter is usually a little bit, 3-4.However, you can always replace it, if desired, at the same time try to choose the model that have a jumper with two ball valves.

Although this additional element as a jumper, and is integral with the dryer, but is an integral part of it, and, very important.When all of a sudden it becomes necessary to repair or replace the coil, both tap is enough to turn to a different location (just a half-turn).Then the water will run on the bridge, and replacement towel warmer in the bathroom will be made without any problems.If desired, such a system can be embedded in the heating risers in the living room, which will provide an additional source of heat and a place to hang clothes to dry.

How to choose an electric heated towel rail in the bathroom?

If WAN communications do not include the coil, and to violate the integrity of the risers do not want to, you can install and electric towel rail in the bathroom.In this case, you will be completely independent from the water supply, and on the walls you can hang a few designs. only limitation - such systems can not be installed closer than 60 centimeters from the bath, sink, bidet and toilet .Also, be sure to hold ground, which is not always convenient, if in the bathroom there is a washing machine and other appliances.

On the other hand, this type of dryer is much better flow into the design space, as it does not require pulling of tubing.Necessary for wire systems can be routed directly through the wall to the point of connection with the device, which means that the power will not be seen.If you need to transfer the towel warmer in the bathroom, make it possible to be in a few hours, to prepare a new place and securing it serpentine previously removed from the wall.With all these benefits of energy are not at a disadvantage, they are relatively small, about like a light bulb.

The good combination of towel for the bathroom?

Those who do not have such systems may well wonder if needed in the bathroom towel rail.Even if you are not going to use it for other purposes, an additional source of heat in the room will not be superfluous, especially where a lot of moisture.But taking into account that at the time of maintenance work on the eve of winter DHW pipes disappears, and constantly nourished dryer electricity, do not want to, you can use the integrated version.This may not necessarily be the coil, generally, heated towel rails for bathrooms take different forms: "ladder", "wave", round or arched design.

Make dryers made of brass, copper, stainless steel or black, the latter option is usually chrome plated to improve corrosion protection, which, however, does not protect against limescale.

At high humidity in the bathroom does not hurt, not only in winter, but in summer the room was quite chilly.And, not to choose what to install heated towel rail, water or electric, can be placed on the wall version of "two in one".That is, besides the fact that the dryer through a pipe under pressure to circulate the water found inside the space and another electric heating element which, when the coil is connected to the heating system will work in the summer.And during periods of very high temperatures outside the dryer can simply turn off the power.