How to lay laminate flooring in the apartment quickly and efficiently

Prepare base and tools

Before starting to lay the coating, it is necessary to prepare the base and a number of tools.Typical mounting kit for laying laminate include: a saw or jigsaw, hammer, plastic sheeting, ruler and pencil, wedges, bar for podbivaniya laminate substrate (2 mm), clamp (intended for flooring planks last).Once all the materials are ready to begin surface preparation.It must be perfectly flat.

recommendations. Stacking is allowed on the floorboard, linoleum or any other surface, provided that it is perfectly flat.In no event it is impossible to carry out the installation in saunas, bathrooms and showers.This will lead to delamination material.

First check the base, it should be no sharp fluctuations (up to 3 mm) and the roughness.If the surface is not ideal, it is performed its alignment.On wooden surfaces (chipboard, parquet, massive board) curvature eliminate milling unit.In concrete applied self-leveling screed.Next, check the rigidity.No portion of the cover must not sag under the weight of a typical person.If the board is not strong, then they must be replaced.Next, lay a polyethylene film.

Installation laminate

Before laying the planks of the boxes removed for a few days, so that they "got used" to the current temperature and humidity.Plus, it is important to pay attention to the material itself.It must be intact and whole.If there are defective strips, they can not be used.Start laminate installation, video algorithm is presented on our website, it is necessary so that the incoming light from the window fell in parallel seams cover.In the case of the flooring planks on a concrete base previously laid polyethylene.

It is necessary for normal vapor barrier.When the installation is done on wooden boards or linoleum, the polyethylene layer is not required.The ideal is the use of the substrate, which also provides waterproofing, sound insulation, and ventilation effect.

styling itself begins with the fact that forming the first row.Thus between the wall and the coating should be a gap of about 7-15 mm.To this end, specially installed wedges.These clearances are necessary in order to avoid obstacles in the further narrowing and expanding coverage.

If you suddenly find that the laminated board "stand on end", be sure you have not made due to the distance gap.slats stacking direction - "the" mount - locking manner.Here are two types of connections common: «Click» and «Lock» locks. first - collapsible, the second - the latch.Once you have laid the first row, proceed to the second.While laying method is desirable "half board".So cover looks much more aesthetically pleasing.

laminate Dismantling

As already mentioned, this coating is also easy to dismantle.However, the question arises - removing the laminate? complexity of dismantling depends on locking system.If the connection «Click», the process goes fairly quickly if «Lock», it takes more effort and time.However, beginning in any case, you need to remove baseboards.This will require a screwdriver and a screwdriver.Then proceed directly to the strips.

necessary to gently pry the first board and open the lock.The same is done with the new ones.In this process, the main thing is not to overdo it and do not use excessive sharpness, as this may cause damage to the coating.Perform work accurately.It is also important to remember that the coating can be dismantled only a certain number of times.All depends on the manufacturer.In general, all this, so the question - how to disassemble laminate, no longer has to occur.