As oblitsevat tiled oven , with no experience ?

Preparation before laying

tiles for stoves must be fireproof.Before starting work, you need to calculate how much you will need.Having estimated that by purchasing this number, add another 10-15% of the total.This additional tiles come in handy when cutting or damaging material.Those tiles that remain, will be necessary to replace elements fallen away during operation.In addition, the crosses are bought by 2.5 millimeters, cement, glue, rubber staple cutter and a trowel grout.

Note!Buying all the necessary advance will do the job as quickly as possible.

Facing tile stove begins with cleaning the surface of the excess plaster.Also deepened all the seams, and the dust is removed.Plaster fireplace is made of sand and cement mortar, which is mixed in a ratio of one to three.Before you start plastering the entire surface abundantly wetted with water with a brush.Be sure to use a plumb and level with the work that the layer was flat, because of this ease of lining depends.

perform finishing

The next step is to install a special grid with 50x50 millimeters.For its fasteners can be used metal anchors or screws.Screwing it in a pre-prepared holes.Often used for fixing wire mesh, which is laid in the joints.It puts it in increments of 15 cm.Facing the oven tiles is performed using a heat-resistant adhesive.Experts recommend to add table salt into the adhesive.Mixing is done in proportion kilogram of salt in a bucket of glue.This allows the adhesive to hold a water that will enhance its quality.

Stacking made on preheated oven.A certain temperature must be maintained throughout the entire operating time.Installation starts from the bottom.To all the seams were the same, crosses between the tiles are installed.Putting a few rows of tiles, you need to check them out with the help of a plumb or level.Laying best corrected immediately, as after drying the solution to make it will be impossible.If you first have to perform the finish, trying to understand how to make the stove cladding tiles, video process on our website will help in this.

Note!The furnace temperature was in the decoration should be the same as in the heating room.

As oblitsevat tiled stove from plaster?

use of gypsum tiles for lining furnaces in recent years, is gaining widespread.This material has the following properties:

• strength;
• insulation;
• Soundproofing;
• Aesthetic beauty.

Gypsum is an environmentally friendly, non-flammable and maintain a good indoor climate, making it an excellent material for lining furnaces.The thickness of such plates 6 to 8 millimeters.Finishing plaster material has its own characteristics.Stacking is joint to joint, seamless, both in finishing ceramic tiles.Attach it can be standard glue mixture and mastics.After packing it can be painted in any color.For this purpose, latex, alkyd, acrylic, oil paints and varnishes.

Note! To obtain different colors of tiles, you can first lay out the elements that will be painted in one color, paint them, and then glue the other elements.