Mini circular saw for home use

Produce base

To make the machine of hand tools, need to make a special table.As a frame, you can use wooden or metal box, which are connected to each other board section 50 millimeters.On top of this base is attached table.Tabletop can make two steel plates 4 mm thick.You can also use thick bars.In the middle of a bridge, they bound plywood 20-25 mm thick.The gap between the plates must be left in the 10-12 millimeters.

Important!It is necessary to achieve a perfect parallel to the inner edges of the plate.

tool will be attached to the bottom of the table so that the saw is in the middle of the gap between the countertop sheets.In this position, a small circular saw attached to a table in a drilled hole.In order to make a smooth table top, all the holes counterbore and tightening the screws.The gap between the plates are inserted into the surface of the ear with a slot for the saw.

Engine Mounting

deciding how to make a small circular saw, it is necessary to consider the construction of the transmission mechanism from the motor to the saw.Of course, you can put a small conveyers directly on the motor shaft, it will be much easier.However, such a system capacity of small conveyers will be significantly lower.As such a mechanism can be used on the bicycle spindle.Spindle - a body in which the shaft bearings.It is cut off from the frame with a hacksaw.Asterisk is not required, because it is better to replace the star of the motor

D6 or D8 .For a tight fit on the shaft sprocket must be made bushing.

to install on the saw blade spindle is necessary to take into account the diameter of the bore and, on this basis, define the outer diameter of the sleeve to the adapter.By the spindle sleeve must be fixed at several points.To the body of the spindle assembly mounted plate thickness of 5 millimeters.An asterisk is attached to the shaft, which should be 2.5 times greater than the one that is mounted on the spindle.They need to strictly fix the same plane.After fixing all the details put on the chain and circular saw is ready.

Important!It is necessary to ensure that the horizontal hinge had no backlash.

mini circular saw "in a box»

above method allows to make homemade mini conveyers to work in the barn or home workshop.However, they still need a stationary countertop.Now look at how to make a mini circular saw without her.For this you need a body.The side of his wall are made of aluminum plates thickness of 5 millimeters.He is going to help over and bolted.

The top panel is made of steel, and it is fixed saw unit.Also mounted on top of a sheet of aluminum that forms the saw surface.Body made of metal for the reason that it will have a rectangular shape.In the manufacture of wood as it is trapezoidal.However, if it does not matter, it can make a wooden enclosure.

After mounting block installed engine that you have chosen.To adjust the cutting depth necessary to tighten the two screws.The first screw is, in fact, raises or lowers the unit.The second is needed to secure the unit to avoid it moving.Further guides are made, which can be made of simple metal parts.

Note!This mini circular saw can be freely stored in a closet or pantry.