Build Daily

Ceilings

August 12, 2017 18:07

Ceiling tile seamlessly as a non-standard version of the trim

Preparing the ceiling and materials to work

If joints between the tiles are, head over it does not look very nice.Ceramic tile without seams on the ceiling will not be held, as the seams negate its geometry errors and compensate for the difference of the temperature of tiles and extensions of its foundation.

The emphasis in this case is the lack of finishing seams, because it gives the ceiling a more aesthetically pleasing and presentable.Manufacturers have come up with a new decorative tiles seamless stacking technology.Expanded polystyrene ceiling tiles make the surface smooth, because it hides the altitude differences of the surface.Laying the tiles without joints - a process simpler than itself preparation for work.

Before laying the necessary to carefully prepare the ceiling: a good blur, remove paint, wallpaper glue residues.The following is to eliminate the most serious defects.This can be done with the help of plaster or putty.Then, the surface should be primed.

For two or three hours before installation of the material should be unpacked, lay on a flat surface and allow to lie down in the room.To get smooth and beautiful ceiling without seams, tiles should be sorted, it happens that the party across the defective copies.

tile ceiling without seams - correct markings and careful sticking

Before you glue the ceiling tile seamlessly, you must mark the area properly.First you need to find the center.To be noted that the middle length and width and have two mutually perpendicular lines, and their intersection is the center.Thus, the ceiling is divided into four parts.

also worth checking out the diagonal of the room itself.When visible abnormalities is recommended to choose a tile with a fine relief pattern.It can be laid in two ways: parallel walls and diagonally.In a parallel installation need to consistently complete all four parts of the ceiling layout;the diagonal - the first tile to be glued on the center to all its corners clearly coincided with the marking lines.

For laying of ceiling tiles is recommended to use a water-soluble transparent adhesive or liquid nails.The adhesive should be kneading, clearly following instructions.The adhesive is applied on the perimeter and diagonal tiles fine comb or narrow spatula.

Then each element is glued and pressed, respectively, marking the whole plane for 10-15 seconds.Then you need to remove the excess glue with a clean cloth.Avoid gaps between the tiles in subsequent assembly.

Harvesting sudden lapses - are sealed seams

Although the technology is called seamless, tight seams only in theory.They are still present to a thickness of 1 mm, and if the ceiling is not a clear diagonal, and even more.Over time, the joints between the tiles will darken and will be evident.To avoid this, you want to seal the seams.

This procedure will not take much time and effort, and the dark gap subsequently will not be evident.Before you seal the seams on the ceiling tile, you should find a suitable composition.Seams can embed a special grout, acrylic sealant or putty.

Silicone Sealant is not suitable for this purpose, since it turns yellow over time.The seam of the tube is filled, if you are using a sealant, or using a narrow spatula, if you use a mixture.

necessary to ensure that the entire seam was carefully filled, no gaps.After that, clean cloth, remove excess formulation used.The final touch - stick ceiling moldings, decorative outlet under the chandelier and color, if necessary.

instagram viewer

Categories

Latest Blog Post