Sewerage in the house - master the delicate construction of communications

Water supply and sewerage in the house - especially

coexistence The world does not stand still, and if earlier domestic sewage was accompanied by a lot of ugly pipes, but today everything is much more aesthetic.You can buy tubes of different diameters and forget about the welds.Plastic has a huge advantage, as the so-called metal and plastic in general superior to conventional steel pipe several times.

Sewerage in a wooden house has its own characteristics, which you should know.Beauty and other leave on the second plan, and for the first functionality goes.Depending on what we will be rafting on it, we choose the right diameter of the pipe, but do not forget about the slope, because water must flow.

House drainage requires some training and tools.You will need a jig saw, drill, hammer, hammer, screws, screwdriver, that's all.As for the work, the first thing you need to raschertit sewerage plan on paper, and then calculate the required amount of consumables with a margin of 10 percent.

Home drainage - practical calculation

Sewage from one or two wash basins must pass the pipe with a diameter of 15-20 mm.That's enough to seriously stream and small blockages.As for the toilet and the bathroom, and the two are combined in one tube, then there would ideally 40-50 millimeters in diameter.Do not get stuck, that's for sure.

Conclusion sewage from homes best accomplished pipe diameter of exactly 50 mm and the one that goes behind the house, and therefore under, must be 70, or better still 100 mm.

Also do not forget that the local sewage system for the house throughout its length should have a small angle of inclination, or a need to install a pump for sewage, or - work for nothing.

Sewerage - start installation

proceed directly to the installation system.Following the drawing, each crane fasten so-called knee, which fix the main pipe, and with the level at a slight slant, naturally down derive drains.This is best done during the construction process, before laying the floor.

This will provide the greatest attraction, as will be seen all the pipes.Yes, and the sewage out of the house will be located exactly at ground level, which will help to calculate the slope of the main pipe.

So, you've set the "knee" for each crane, is now fastened to it the selected pipe.Making drains in the house for yourself, so take your time and every 50-80 cm attached to the wall or any place fasteners, and which lays down the pipe itself.Best of all, in one place to create a connection of pipes into one head.This should be done not far from the exit of the sewers.

slope of one meter must be at least 1 cm, in an ideal - 1.5 cm. This will create a faster flow optimally without sediment and other expensive equipment.

quits

After collecting all the pipes into one with the help of adapters and tees, making himself at home sewage release.To this end, through a prepared hole we are releasing our main pipe that will go under the ground.At this point, outside the pit has to be prepared and have the same inclination, and preferably 1 cm longer than the house.

Outside pipe would be nice to warm glass wool, and remember, it must be held at least 1 meter from the surface.The fact that the earth is compressed and frosts can crush our pipe and at such a depth and warming it is not threatened.This is important, because of the exit of the house meter depth should be observed.Embedded in the main sump or in a barrel, you have prepared in advance.

Everything is ready, now you know how to get the sewer out of the house, and how to build it.Believe me, it is better to do it yourself, take the master for a lot of money, and if you have an extensive network of pipes, it all translates into a fortune, which is sometimes more expensive than the materials themselves.It just so happened, water supply and sewerage system in the house is no longer a luxury, but if there is no order, and the other does not seem life honey.