Garden arch with their hands

Wooden garden arch going pretty easy and does not require large cash expenditures.It can be installed at the entrance to the garden or on the territory of the suburban area, to curl in different colors, such as rose or vine or ivy.The product will not only give the area an attractive appearance, but also will serve as a zoning element.

Drawings

Materials and tools

to get in the end is really a beautiful arch, you need to use timber and boards, pre-treated with antiseptic and covered with lacquer or stain.For the manufacture of small architectural forms will need:

• 4 beam length of 2.5 m;
• 2 boards in length 1.9 m;
• 4 boards length 1 m;
• 8 racks section 2X2 cm length of 1.5 m and 16 cm;
• reek section 2X2 10 cm length of 0.55 m;
• 7 rails section 3X3 cm length 1 m.

Recommended thickness of the boards at least 2 cm. Also need wood screws, screwdriver, saw, measuring tape and a pencil for marking.Before starting the work necessary to make the circuit and carry out training boards to build garden arch with their hands did not require extra effort to complete clearance after assembly.

Start of

necessary to perform all boards sawed off to give the arch of the eastern species.It is necessary to separate from each edge of the board back down to 5 cm and make a mark.Then back off the top about 1/4 the height of the material, to make a mark, and then connect the two data points.Through spend sawing.

Next, you need to dig all 4 timber to a depth of about 0.5 meters. The distance from the extreme points (considered to be the width of the 2 poles) between the left and right column is 1.5 m, and is equal to 55 cm between the front and rear.After instillation need to ensure the same height poles.

Build garden arches

After poles dug you can proceed to the attachment of the front and back of the board (1.9 m).From each end of the two boards, focusing on the upper part of the uncircumcised, you must retreat to 20 cm and put a mark.Then attach these elements according to the markings in the upper portions of the pair of front and rear pairs of legs.Work must be done carefully so that the upper edge of the boards and the boards of the garden arch for perfect color match at level.

Then attach the side boards.Attached photo garden arches allow to see that the bottom of the board are located directly below the previously attached.No padding is not necessary to make between the parts.Previously from the edges of the boards, focusing on the top, measure 25 cm. According to points bolted to the posts.

To perform side crates, just look at the photos.On the one hand longitudinally on rails mounted 1.5 m. To two poles and two inside to the bottom board.The approximate distance between the rails is 15 cm Further cross rails are attached:. 4 pieces underneath.0.55 m by one and the same top.Between them there are 4 small rack 16 cm, as shown in the photos.This procedure is repeated for the other side.

upper crate

to arch for the cottages, made with his own hands, looked attractive and could give a little shadow to manufacture the upper lath for climbing plants.It is necessary to measure from one edge of the top board 11 cm. 6 rails, length of 1 m from the edges measure 25 cm. Further on-stamped attachment points to hold first transverse slats measure 30 cm to the next, and attach it to the board.Repeat for the remaining 4 strips.Over formed "ladder" in the middle to attach the rail, length 1 m, 2-5 beat her to the rail.

to garden arch was really the eastern species can examine the video for her execution.But it is quite possible to be limited and hanging lanterns, giving it great elegance.With proper pre-treatment of the product will last for many years, but in the conditions of heavy rainfall is possible to further close its film.

Video manufacturing garden arch with their hands

Metal arch for roses: