Bungalow with your own hands

purchasing a suburban area, the owners are beginning to bring their tools for tillage equipment, or unnecessary, yet things.Space to accommodate all usually lacking.In order to build capital structure need expensive construction materials.Hiring builders, too, is expensive.Bungalow made with their own hands, will be an excellent way out of the eternal problem of shortage of square meters.

Materials

need the following construction materials:

• timber;
• linings;
• cement;
• sand;
• rubble;
• fittings;
• OSB plates;
• roofing material.

Foundation cabins

To begin, you must make a clear layout and territory.Make a small indentation (10-15 cm).In his sleep sand, compacted.Then put the geotextile, it has a layer of gravel of 5 cm. Then, set the formwork, based on the height of the floor of 10 cm. The next step for the future of the whole area of ​​the foundation rebar tie.Now we proceed to the concrete pouring.While the concrete is grasped, set the foundation bolts on the base perimeter in freshly poured concrete.They will need to mount the base of the wooden frame.After pouring the concrete, you need to wait a few days until it hardens and takes the necessary strength.

Walls

medium size timber is used for the construction of the walls of huts.Four beams that need to be attached to the foundation bolts are the basis for the walls.

erect the frame should be exposed, the level, extreme support.

Then they fixed upper beam and side, a temporary board.

top bar will serve as a reference for the height of these supports.According to this principle exhibited all four walls.

distance between the supports should be about 50 cm. Not exactly defined wall, in the future, affect the construction of the roof.Therefore, during installation, you need a tape measure to measure the diagonal.They should be the same length.The level of control the height differences.For doors and windows are left special openings.

where you can view photos and videos on how to build a shed with their hands.

roof gable roof is suitable for framing cabins.

First, put up beacons for rafters.Installing them is necessary for the center of the wall in its upper part, as shown in the photo.

Further, they are connected transverse beam, which will serve as a support for the rafters and will be the peak of the roof.

Attach the rafters can be like nails and special fasteners.Depending on the size of the cabins may need additional reinforcement of the roof.To do this, you must take extreme rafters fasten the rack.They will support the crossbeam between the extreme beacons, thereby not allowing the roof to cave in under their own weight or extra load.After that, the crate becomes clogged.

frame cabins ready and you are ready to trim.

Casing frame

suitable for wall OSB plate, it can sheathing and roof.

doors, too, can be built from a small timber and OSB.To do this, measure the size of the door opening.Then, from a bar to knock down frame and sheathe it.This door will be easy, so it will not sag and warp.

Manufacturing cabins with their hands coming to an end.The final stage is the lining of the roof and the roof.

The fastest and easiest way to shed oblitsevat - painting.However, there is no hard and fast rules or conditions.

Everyone chooses the material for the roof and walls at its discretion.For example, the roof can be covered Ondulin and wall sheathing exterior metal siding or clapboard (previously, by treating it with an antiseptic).

After facing cabins ready for summer residence, and can be used for other purposes.

Video building cabins with their own hands

Drawings cabins:

Step by Step: