Build Daily

Floor

August 12, 2017 18:05

Laying laminate diagonally

click fraud protection

Laying laminate diagonally, as a rule, very rarely used, and this is a great method to get the visual expansion space volume and hide the irregularities of the walls.Best of all, he looks in the rooms that do not contain right angles.Classic laminate installation in these areas will show all the irregularities of the walls, which had a negative impact on the appearance.

Content

  1. laminate calculation when laying diagonally
  2. tool and preliminary operations
  3. scheme laminate laying diagonally
  4. Videos laying laminate diagonally
  5. Photography laying laminate diagonally

calculation of the laminate during laying diagonally

Many people mistakenly believe that when laying laminate flow diagonally uneconomical, has a lot of waste and require advance purchase of material with a huge margin.Correctly approaching this problem, it suffices to acquire laminate in an amount which exceeds by 5-15% the room area.

tool and preliminary operations

For a laying use the same tools as in the classical: hacksaw, tape measure, a bar, a ruler, a hammer, a pencil.Preliminary operations consist in trimming a solid foundation, sweep the dust, the substrate styling and placement of the spacer wedges.

circuit laminate stacking diagonally

be appreciated that laying diagonally not require accurate angle of 45 degrees, it may be from 30 to 45. In order to hide the joints, the panel must be positioned so as to coincide with the long stitchesdirection of sunlight incident on the coating.

The required size of the gap from the wall is 10 mm.Stacking the laminate can start diagonally in two ways.First folding means in the very first corner of the room panel, and then moving the window in the direction of the door.In the second method produces stretch the yarn between two angles and focusing on her, mounted the first row of laminate.

necessary measure off precisely the latest of the panels, while noting the cut line on both sides, do not forget to comply with the required size of the gap.In the standard method of stacking the cut piece is used for the subsequent series.But it would cut a huge chunk to make a new angle is needed for diagonal installation.To save the material, you're just putting off the severed part for use in the opposite corner.

The most economical option - it's styling, which starts from the middle of the room and is directed into the left corner in relation to the incident rays of light.For the correct vision of the future location of the panels in the room, with a pattern definition and understanding of the flow of material, experts recommend to estimate paper laminate stacking scheme diagonally.

To begin with, fit the panel on the left side, then on the right, but not necessarily the first line should be directed into the left corner.Castle laminates directly connect end caps lock, and then with the next series.Each row is staggered, you will need to comply with the size of 30 cm between the end joints.In order to avoid bouncing panels, any number of adjacent edges pressed down load.

At the final stage of laying it is necessary to remove the wedges.The gap that is formed between the laminate and the wall concealed installation plinth is attached solely to the walls.

With video and photo laminate laying on the diagonal, you can learn more about a little bit later in this article.

Videos laying laminate diagonally

Photography laying laminate diagonally

instagram viewer