Paul plywood on logs with their own hands

floor alignment for subsequent coating requires the observance of the accuracy and obtain the same level of the entire surface.Fill a new tie in the room is not always convenient, and quite expensive.An alternative is a floor made of plywood, which will be installed on rails attached to the old screed.The thickness and width of the lag should be about 5 cm, and the length should be at least 2 m.

Fixing lag

to the floor of plywood on the joists, made with his own hands, was really smooth, it is necessary to carry out the installation of the first timber to be installed on a level.Carry out work following the end of the finishing works of walls and ceiling.

lag Installation is carried out not on the screed and to enclose scraps boards or beams.This system allows you to align even very uneven surface with sudden changes or the presence of recesses or projections.

Subsequent logs are aligned with respect to the previous item.This will maintain a given level throughout the room.With underlay roofing planks should be used.The supporting elements of wood may change shape with increasing humidity or temperature changes, so additional layers will allow to keep the resulting level surface and protect it from curving.

To perform the correct alignment of the plywood floor, you must have the logs at a distance of about 50 cm. Away from the wall should be small and be about 3 cm. Altitude is chosen individually, but when fixing should take into account the thickness of the boards, and a thicknesssupport elements.

therefore necessary to use dowels, at least 3-4 cm greater than the sum of these indicators.A mounting plywood sheets should buy screws on 2-3 cm larger than the thickness of the acquired topcoat.

plywood Stacking

Running laying plywood on the floor only after its preparation.Jigsaw plots are cut pipe, angular protrusions walls.The thickness of the sheets must be purchased at least 3 cm, because the resulting coating does not sag under the weight of the person and installed in the room of furniture.

Positioning plywood needed so that the joints of sheets come around the middle of the lag.This will allow to work correctly and to ensure the reliability of the entire structure.

between joists and plywood sheets of roofing material is placed.This will avoid the "run" of the coating and its deformation during the subsequent operation.

Location plywood relatively lag should be cross.Each sheet is mounted not only at the edges, but the entire length of the support.It is advisable to avoid fixation in those areas where people will be walking.

precaution will help prevent damage to the floor and ensure its long-term preservation.Detailed installation photos design will allow to see the assembly process of a plywood floor and proper fixation sheet.

understand how to do half of the plywood is not only smooth, but also durable, allow specification of layout sheets.The most correct is the displacement of the pieces: it is not necessary to carry out the installation with a single connection line for all adjacent pairs of plywood.This may lead to a skewed design.To familiarize with the intricacies of the job will help video describing the process of creating high-quality and durable floor made of plywood.And after the proper installation, you are ready to finish the smoothed surface of any floor covering.

floor installation Video of plywood with their hands