Kitchen furniture made ​​of plasterboard with their hands

fully furnished in plasterboard can be for any room in the apartment.As a rule, are made of plasterboard fixed, built-in wardrobes, cupboards and shelves for various purposes.This inconvenience is well compensated by the low cost of materials and ease of installation.Fit furniture to the desired size, make and install their own can any.

positive aspect of such furniture - an opportunity to realize their wildest design fantasies.Plasterboard can be given any very unusual shape, a large palette of pigments allows the paint furniture in the appropriate color of the interior, and if desired or necessary, it is easy to repaint the other.

surface of kitchen furniture made of plasterboard can paste over duplex for painting or relief washable vinyl wallpaper.Depending on the design concept, uses self-adhesive PVC film and other finishing materials.

Drawings for furniture made of drywall

First you need to make a drawing of plasterboard furniture, photos and detailed instructions can be found on the Internet.The project can be ordered from the masters, or on the basis of measurements, their own sketch on paper.

1. defined the place for the future of furniture made of drywall, make measurements using a tape measure and spirit level, determine compliance with the horizontal and vertical planes.Carpentry area check the angles at several points dock floor and walls.Spend at least three measurements on vertical corner joints of the walls and display the degree of difference.Builders do not always adhere to strict parameters and the possible differences of the walls must be taken into account in the design of furniture of plasterboard.Visually subtle flaws builders can create significant problems if it erect in a straight line, excluding the corners of such deviations.
2. Sketch a plan diagram of a pencil on paper, try to portray the furniture in the three-dimensional plane - a general view, side view and front part.A drawing with dimensions will help you to make furniture of plasterboard with their hands and calculate the required amount of material.

Mounting frame furniture Plasterboard Kitchen

Inspect the kitchen space and determine the location of the new furniture of plasterboard.If the kitchen has a niche - you can use them successfully.On request, the kitchen can be built separate elements of kitchen furniture - cabinets, cupboards, cabinets - cupboards or make a full kitchen.

1. Start with markings on the floor and walls, apply the chalk with a long flat rail line on the place of mounting profile brackets for plasterboard.Select the profile to guide and uprights with galvanized metal thickness of 3 to 4 mm.And will take the wooden beams of the appropriate size, to fill the "U" - shaped profile.Timber should be well dried, as it can then twist.Choose a water-resistant gypsum board - thickness from 6.5 to 12.5 mm, it is most suited to the atmosphere of the kitchen.
2. Profile Fasten to the walls and the floor with screws and plastic dowels.The contact points between the profiles with the floor and walls, attached padding which damps the possible vibrations of the building.Between a guide and rack profile fastened with small screws "bugs."For arched and smooth bends trimmed side bumpers galvanized profiles scissors for metal.Step notch for custom configurations depending on the degree of bending is from 0.5 cm to 5 cm. Sometimes it is necessary to trim the corners protruding trapezoidal.
3. Horizontal rails for shelves, which are planning to place weighty objects or household appliances - for example: a stack of ceramic tableware, a TV or a microwave oven, it is desirable to strengthen the profile of thicker metal, and be sure to insert into the middle of the wooden beams.

Features kitchen furniture putty plasterboard

base surface must be prepared.Corners and joints are polished with sandpaper or a special mesh grater.Irregularities are cut with a knife for drywall installation.

1. For interior and exterior corner joints can be used plastic or metal perforated angle.There is a flexible corner arched or curved angles outside the box.Perforated corners are thrown on the putty.Attachment points, recessed by 1 - 2 mm plasterboard treated with anti-corrosive primer and putty overwritten.Straight joints gypsum fabric reinforced PVC self-adhesive reinforcement tape.
2. Before putty, nipped and polished surface of the cover of the universal primer.Primer and putty is desirable to get one manufacturer.Grown dry plaster with water to the consistency of thick cream or purchased ready-liquid plaster.To align the bases and a layer 2 - 3 mm starting putty.A small spatula, a width of 8 - 10 cm plaster is applied on the edge of a broad spatula, a width of 25 cm and is applied evenly to the base surface of the kitchen furniture made of plasterboard, and then smooth down.
3. After drying, the surface oshkurivaetsya, a layer 1 - 2 mm finishing putty and left before the final drying.Finally, the surface is polished carefully.Circular movements, fine-grained abrasive material on a wide grate.The surface is primed deeply penetrating universal primer and painted in the appropriate color, water-based paint.

Design solutions for decoration kitchen furniture plasterboard

drywall finishing materials for a lot.On the surface can be pasted wallpaper or self-adhesive PVC film, natural cork or ceramic tile.It all depends on the particular design of the kitchen drywall.

Coating latex paint

painting - the most simple and easy way to the final finishing of kitchen furniture made of plasterboard.The surface is covered with water-based paint, brush or roller.The required tone is achieved by adding pigment dyes.It should be noted that the drying saturation of colors is weakening, and eventually, under the influence of sunlight may fade altogether.Paint plasterboard furniture at least twice.The first coating latex paint, after drying will show the degree of color saturation.The second layer can lighten or vice versa, to saturate the color scheme and achieve the desired result.

wallpapering on plasterboard base kitchen furniture

side wall cupboards made of plasterboard can be wallpapered in tone or combined with walls.Wallpaper glued as well as the walls.Kitchen fit tight washable wallpaper.Duplex wallpaper for painting have waterproof and light protective coating.As a rule, they have an embossed pattern or picture.Good fit double layer vinyl wallpaper imitating wood, burlap, ceramic tile, etc. Vinyl -. Quite durable, designed for cleaning material, it almost does not fade and is well suited for the kitchen.

Front doors for kitchen cabinets made of plasterboard

the kitchen, just need to have cupboards with doors.Some shelves and niches can be closed by glass doors, the other - the facades of moisture-resistant MDF or wood.In the shops of furniture accessories offers a variety of fronts and mounting hardware for them.Beautiful pens always catch the eye and set a certain tone interior.

Lighting for kitchen furniture

Local lighting in the kitchen - very convenient and practical.Built-in kitchen furniture spotlights plasterboard perform a dual function.They will be a harmonious part of the interior and the functional coverage of the necessary work zone, while saving energy.Location luminaires thought out in advance, and the assembly and installation is done at the time of the construction of the frame and fixing plasterboard.