How to apply the plaster

required for

• spatulas of different widths
• Trowel
• Construction usually
• primer solution
• Caulking
• Rollers

Preparing for

finishing Initially assesses surfaces - eliminates visible irregularities,nails, screws, seams between sheets of drywall and trim the corners of reinforcing mesh.The previous layer of plaster is removed with a spatula, after which, according to the manufacturer's recommendation, you need to prepare a primer.If you want to align the surface of the wall of brick, set grid and mark special Maçka, which are designed to indicate the surface alignment.

Fillers are prepared according to instructions with the help of the construction of the mixer, making sure that the weight was perfectly homogeneous.If the material is too thick, it can safely be diluted with water, mixing thoroughly.It is recommended to ensure the consistency of the mixture of plaster as a thick cream.

How to apply putty

To get started, you need a spatula 10 cm wide and two-handed trowel.Spatula mixture from the tank is applied to the trowel, the mass of which is uniformly applied to the wall.The tool held in the horizontal position, and the putty is applied vertically.

Once material is applied about 2 square meterssurface by building regulations in the form of a trapezoid removed the remnants of putty - tool normal to the layer of the mixture is carried out, and look at the remains of the mixture.Surface smooth feel after plaster remains on the entire length of the rules to achieve this, the mixture is applied on the wall in several layers.

The next layer is the finish coat, which is used as a basis for painting or papering the walls of wallpaper.The narrow spatula mass recruited and superimposed on another spatula, width 45 cm, and then distributed over the wall.The direction can be disregarded, the main monitor the uniformity of the surface coating material.

Walls shpaklyuyut at least two layers, after which the walls are left to dry finish.Above the walls is fully aligned primer layer, which can be used also to correct certain defects if necessary.

Applying putty on the wall

To putty walls at home you need to cook the mixture - the powder is diluted with water according to the instructions, stir with a spatula or mixer.Weights should last somewhere in half an hour of work, as it tends to harden quickly and then use it anymore.

Before you start leveling walls are eliminated small cracks and holes - knife trimmed their edges, cleaned of dust.On the surface of the cavity is applied to the soil after it has dried, it is filled with putty and leveled with a spatula.

After the irregularities are eliminated, it is necessary to dry plaster, after which the wall is completely covered with primer.Small trowel applied to a wide mixture is then spread on the wall, moving the tool in the side and from below.

putty first layer is called a start, it reaches a thickness of about 15 mm.The next layer - the finish mixture, which hides minor irregularities, achieved the smoothness of the walls that once it dries and primers allows boldly painted or wallpaper paste over the surface.