Proper bonding veneer

glue veneer with your hands is quite a popular procedure among those who makes repairs, let's understand the same - how to glue veneer.

Before it is necessary to conduct a thorough inspection of the surface that is subject to facing, and then - to eliminate potholes, bumps, defects and damage, of course, if any.

better if the surface treatment is carried out with the use of skins.

What often subjected to veneering?

Usually shponiruyut facade or wall panels are made of MDF.Also very popular interior doors made of natural veneer.

In general, this material is pretty good and has an aesthetic appearance, so it can be glued to any wood surface, without fear of harm to the general interior.

In addition, the cost of veneers in various construction markets is not high, which allows you to transform your furniture, doors or interior without incurring significant financial costs.

Important nuances gluing

If there is a basis in the form of softwood lumber, a mandatory check for resin acts.

With its presence on the surface, it should be scraped off with a knife, then wash station with a solution of soda ash or acetone 25%.

Particular attention should be paid to the fact that the glued veneer to the knotty surface will be difficult, so you need to eliminate them, and then land on which they were embedded using plugs with glue.

Video:

As for veneer moisture, it should be on the order of 8-10%, with respect to details of stones, this figure should be 7-9%.

Considering how to glue veneer, I would like to note that it is better to do, using the adhesive protein-based, bone or mezdrovyj.

As a rule, the factory veneer glued using a hydraulic press with a heating mode.

Sticking veneer home catches - in grinding

If it is supposed to be talking about home gluing veneer, here, deciding how to stick the veneers have to use the manual method, ie, very tightly.

Its essence is as follows:

• prepared surface with a special stiff brush undergoes spray it along the wood fibers of a thin adhesive layer.In the process of applying the adhesive, to avoid the formation of lumps or missed areas.Then, after the adhesive is applied, it is necessary to wait for the order of several minutes, after which you can proceed to the imposition of veneer sheets;
• for imposing on the basis of the veneer, the next stage of his crease, which uses a cloth moistened;
• Then proceed to ointments, while iron or lapping hammer is needed for this to warm up to the temperature of 150-200 degrees.This will allow the glue in the ointment warm up and re-dial the stickiness.

Lapping veneer made from the center to the edge along the fiber.

not forget that grinding should exclude the presence of the remaining air or excess glue, thus it should take place until such time as will not be completely glued veneers.