Fences

August 12, 2017 18:05

A fence of corrugated board , with brick pillars with their hands

Fences

click fraud protection

Today, the market walling there are many proposals that use a variety of materials (wood, metal, concrete, PVC), but perhaps the most stout of them is a fence made of brick.

Content

Getting Started
stages erection
Photo fence of corrugated board, with brick pillars
Video setup fence made of profiled sheet with brick pillars

For all its merits, such atype of fencing is only one drawback - the high price.Therefore, experts recommend combining brick with less expensive materials.The best example of such a union can be called a fence of corrugated board, with brick pillars.Detailed instructions with photos and video of the installation of the fence with their hands presented in this article.

Getting Started

Construction fence of corrugated board, with brick pillars with their hands should begin with the drafting.At this stage it is important to consider the location of the gates and entrance gates, as well as technological advice:

pitch span should be 2,5-3m;

fence must be placed strictly on the perimeter;
control the level of soil slope should be broken fence into segments according to differences of height, if necessary.

stages erection

I. Marking the territory for the next fence.

Before you begin, it is important to check with the site plan, then break the pegs along its perimeter.Between the marks tightly stretched cord, verified (by the diagonals) perpendicular to, and then with the help of leveling is an absolute "0" being built design.

II.Production of metal-concrete structures.

According stretched and exposed the level of the laces are formed depressions in the ground.Recommended depth concreted pits for poles must be greater than 1 m, which in the cold season is to prevent deformation of the building envelope (typically deepened to a depth of soil freezing 1.5m).

To strengthen the fence or to add some constructive originality, can be placed between the strip foundation pillars (to a depth of 50 cm).In this case, you should take care of a solid formwork.For its walls can be used as a timber and a 100mm thick OSB.For fixing formwork using a cross-bar, which pour in from one end of the ground and the other nailed to the very board.

In the next step you need to take care of the harness and mounting in the casing of the reinforcing frame.For the manufacture of the frame is best suitable fittings made of fiberglass (10mm diameter) and binding wire.Form the frame according to the size of the box groove.

Next set of metal rib rigidity at the base of the pillars of the future.Then between them fixed fastening, creating a frame rail.Finish the data of the direct pouring of cement solution (grade not lower than M200) are available in the grooves.

III.Bricklaying for columns fence.

you can use any moisture-resistant bricks, but ideally you should pick up beautiful decorative patterns to carry out these works.Each layer of bricks is recommended to fasten a metal grid on top of causing a uniform layer of solution.Be sure to use a level!At the top of the support column should be set to either cement or metal cap.

IV.Mounting sheet metal sheets to the frame of the fence.

In projecting between the support pillars mount (lag of shaped tube 40h20 mm) mounted corrugated sheets with galvanized screws or 5h30 mm steel rivets 3,2h10 mm.