A fence made of polycarbonate with their hands

As the houses adjoining the site fences are increasingly installed fences made of polycarbonate.

The advantages of a fence made of polycarbonate

This material has several advantages over other materials, such as high flexibility and strength properties.Fences made of polycarbonate impressive look and have good light transmission, but it is reliably hidden from extraneous events.

Tools Required

Build a fence made of polycarbonate with their own hands can be anyone who does not have special skills in construction.But this requires the ability to use the right tool, namely: hand drill, necessary for the production of holes, a sledgehammer, which will be required for driving piles, Bulgarian, used for cutting pipes, building level, screwdriver, and special thread of nylon.

installation instructions fence polycarbonate

So, how to make a fence made of polycarbonate with their hands, and what do you start?The work should start with marking.On the basis of the perimeter enclosing territory, is calculated for the desired number of sheets.When markup is necessary to eliminate surface roughness occurring.

fences Laying of the foundation should be carried out taking into account the possible freezing of the soil.The depth of the foundation is typically 0.8 - 1.2 m.The lower part of the foundation of 200 millimeters must be deeper than freezing.

When installing poles for the fence, it is necessary to carry out reinforcement that gives the foundation of concrete and the necessary strength to withstand without structural violations of the possible progress of the soil.Reinforcing foundation intake performed using valves having 10 - 16 mm in diameter.It is important that the reinforcement was produced continuously.

pillars needed to secure the web of polycarbonate, established after determining the required depth for burying them.Fence posts should be installed in the ground to a greater depth relative to the depth of the rest of the strip foundation.

So, if a trench for the foundation of polycarbonate enclosure has a depth of 40 centimeters, the holes for the pillars needed to deepen to 120 - 150 centimeters.

Erecting a fence made of polycarbonate with their hands, photos and videos located here can help.Pillars of metal are set apart at a distance of 2.5-3 meters.Corner bearing mounted in accurate vertical position, which helps the application level, and then filled with concrete.After drying, the posts are welded to the joists in the number of two - three pieces.Cloth made of polycarbonate mounted on fixed structure.

mounted by screws.The distance from the edge of the sheet to the drilled holes must be at least 40 millimeters.Also, mounting can be performed using screws, glue or by welding.

Mounting plates shall be based on the stiffeners, in their direction.In this case, a polycarbonate, to prevent the blade displacement, preferably tightly pressed against the post.Polycarbonate sheets, if necessary, cut easily with a circular saw or other hand instrument disk.

Mounting corner joint is the most complex in the process of joining.You must use a level to ensure that the parties were equal in height.

protective film is removed from the polycarbonate after the completion of all works on the installation of the fence.For fastening the ends can be used aluminum tape.Perforated tape at the bottom ensure a smooth flow of water and prevent the penetration of dirt.That's it.The works are completed.What is built from polycarbonate fence with his hands videos and photos - see below.

photo fence made of polycarbonate with their hands

Videos fence construction made of polycarbonate with their hands