Furnaces for heating homes with water - whether for large areas suitable ?

high efficiency appliance

Water furnace for rural homes have the following advantages: the ability to heat the room is very large, so that even in the most extreme cold enough only twice a day to carry out the firebox of the furnace.The system works due to the fact that in between the heating temperature in the house radiators maintain.They cool slowly, so are able to maintain heat for 6 hours.

efficiency of a furnace with a very high with the whole system, about 85 percent.Also, a large heat transfer is achieved due to the fact that the total area of ​​the system large for small size boiler.Hot fumes from the oven gets very hot water boiler with four sides.At the same time they are heated and the lower heating chamber walls, which are capable of eight o'clock to maintain the heat in between the heating.

All this allows to heat the house twice a day to maintain a comfortable temperature.In addition, this design allows the furnace fuel saving is twice more than the other types of devices.

Pros and Cons of the water system

Stoves with a water circuit more complex in their design, but they also have advantages over simple stoves.Despite the fact that the decision to organize such a furnace would cost you much more expensive, all the costs it will pay off handsomely, as it is very cost-effective and efficient system.You can choose an oven with a traditional solid fuel or run on electricity.Both variants are economical, but electricity eliminates the need to constantly cut firewood, briquettes or coal.Other merits:

• stable temperature conditions;
• heating system operates smoothly;
• Significant savings compared to other heating methods;
• aesthetic appeal of the oven.

only downside is the need to constantly maintain reserves of solid fuel and the high cost of installation of such a system.But, as stated above, these are problems that are not a serious obstacle to choosing the design.

Note!If the system is powered by electricity, there is a possibility to connect additional devices to it.

spread the oven for home water heating

furnace with a water circuit with their hands can do, but you need to know how to perform the masonry.It begins as a simple masonry oven, but after the fourth row of bricks, you must install two lattices.At a laying of the fifth row should make the clean out holes.At the same time the boiler is installed, and it should be installed at the level at which goes to heating pipe.This installation of the boiler will prevent the accumulation of air in the system.

Tip!Optionally, the entire furnace laying of refractory bricks.You can use it only in the combustion chambers.

the sixth row set fire door, and on the seventh is the overlap of these doors.Eighth row should overlap the boiler flues.Ninth and tenth placed as usual, but you need to perform ligation joints correctly.The boiler should not be on either side in contact with the masonry brick.Left

gap serves to expand by heating boiler.Until the thirteenth series is ordinary masonry, and on the thirteenth floor of the lower chamber is done.Eighteenth series of overlapping channel vertical connection.In the nineteenth decided what size will have a chimney top of the camera.

Next comes standard masonry.To know how to build an oven with hot-water heating, it is necessary to consider how to make the pipework.In fact, it is no different from the layout of pipes for any other heating device, so there is no difficulty with it.