Reinforcement strip foundation for the minimum time

reinforcement strip foundation - which means this operation?

Strip foundation - a reinforced concrete band (ribbon), which is a closed loop under all load-bearing walls of the building and evenly distributes the weight to be erected around its perimeter.Properly constructed foundation counteracts the pressure of swelling soil when it is freezing and prevents warping and sagging situated on it building structure.These important properties attached reinforcement strip foundations.

material for reinforcement are metal rods with a diameter of section eight to fourteen millimeters.Armature of a small cross-section is used in the construction of buildings of facilitated type: a frame of wooden houses, low-rise brick buildings.Massive constructions require the same foundation, reinforced with thick metal bars.

scheme reinforcement strip foundation - which is designed for?

foundation construction technology of this type include: digging trenches on the calculated depth of installation of formwork, reinforcement tape monolithic foundation, fill it with a solution, coating waterproofing layer and backfill.For uniform distribution of the load of the building structure to the foundation within the contour strips are building a framework of steel reinforcement, which is called reinforcement.

Proper placement of the frame structure under construction - this is the scheme of the reinforcement strip foundation.

metal used for the frame structures differ excellent flexibility, which ensures a high degree of reliability of the foundation.The very same frame is exactly the same shape of the excavated trench and made according to the scheme of reinforcement.Rules reinforcement strip foundation is very simple and should be strictly observed in the frame construction.Below we describe step by step instructions.

basic rules of the foundation reinforcement

First of all, it is recommended to cut the workpiece.It will:

• longitudinal reinforcement of the same, if possible maximum length.Knowing the length of the tape base perimeter, it is easy to determine the total number of longitudinal bars, taking into account that the frame consists of 4 longitudinal sections and their installation in the ceiling frame at a welding areas should be 20-25 cm.
• smaller transverse segmentsdiameter should be 10 cm shorter than the width of the base.Their number is determined based on the fact that they are located at a distance of 1 m from one another, both the top and bottom grids.
• Vertical bars are cut in the same amount and the same fitting as transverse.Their length is 10 cm lower than the height of the foundation.

Now that all the blanks are cut, you can start making a skeleton.On the ground next to the trench parallel to one another are two longitudinal rod so that the distance between them was a little less than the length of the transverse sections.Over long workpieces distance 1 meter from each other by welded cross members, and in extreme should be 40 cm from the ends of the longitudinal reinforcement.The lower grille is ready.

Similarly welded and the upper grille.At the intersections of longitudinal and transverse pieces to the lower grille vertically welded for this purpose prepared rods.Likewise, their upper ends attached another lattice.One segment is ready.We produce thereby the required number of segments, omit them in the trench, and can be carried out the final stage of formation of the reinforcement cage.