Build Daily

Floor

August 12, 2017 18:05

Laying laminate on linoleum

Installation of decorative laminate flooring - laminate, can be carried out without the involvement of expensive specialists.To do this, you need to know some of the complexity of the process and carefully follow the manufacturer's recommendations.Laying cladding can be made on the tile, concrete, wood, plywood etc.

Content

  1. Should I lay laminate over the old linoleum?
  2. laminate laying linoleum on the technology
  3. Videos laying laminate

Should I lay laminate over the old linoleum?

Quite often, consumers raises the question of the admissibility and expediency of the coating installation directly on the linoleum.Builders argue that such a combination is possible.Moreover, laying the laminate on the linoleum gives even some advantages.Namely, in this way, you can achieve better sound insulation properties of the laminate coating and substantially insulate floors.

However, before starting a coating installation, make sure certain requirements under the linoleum.Linoleum should not be too old and worn, not very soft, dry and quite flat, with no significant irregularities and cracks.Otherwise, the laminate may begin to sag, warp and need to be changed again.It is also necessary to ensure sufficiently well attached to the linoleum base and is glued to the floor.Next, illuminate this question: laying laminate linoleum on whether the support is necessary.Then look at the process of preparation and installation.

laminate laying linoleum on the technology

The fact that under the laminate will be quite thick layer of linoleum is not exempt from the need to equip the substrate surface.As a final act is the material of cork, Styrofoam or foam polyethylene foam base.

Actually, the installation process does not differ from the installation of the panels to the surface, with a pre-laid substrate as video .Guidelines and Policies:

  1. should not immediately start the installation.After the delivery of the material, the panel must necessarily lie down.
  2. It is best to stack the material in such a way that sunlight lay along the decorative boards.
  3. This procedure is laying the laminate on the linoleum with his hands, begins to consolidate two of the first row of panels, provided with centimeter gap between the partition wall and decorative veneer.For these purposes, generally use wedges.
  4. panels should go to "lock on".
  5. Boards subsequent series are applied to already-mounted panels of the first row at an angle of about 45 degrees and snap.
  6. Installing the last row of decorative coating should be made with the use of clamps.
  7. In conclusion, the wedges are removed, and then mount the plinth.

places where the coating abuts the heating pipes or other obstacles that are processed with a drill.The panel cut out the desired shape figure, and after the installation of a piece of the remaining gap is decorated with plastic plates.As can be seen from the instructions stacking panels on top of the old covering a fairly simple process.

Compliance with the rules and recommendations will qualitatively lay panel without having to remove linoleum.Having familiarized with the following visual materials, it can be done correctly and efficiently as possible.

Videos laying laminate

instagram viewer