Setting outlet

Company BCS specializes in producing cable support systems and switch equipment.With the help of these products can be equipped with office and residential electrical wiring space in a modern format.Pipes of IPA «Octopus» allow to provide access to any electrical cables flat zone.And in the case of redevelopment, you can send them to another place, without making fundamental changes in the existing network without difficulty.At arrangement of wiring in the premises of such pipes are usually mounted in the floor, to equip the place for access to the electrical connector.The logical conclusion of such a high-quality systems are sockets and switches «Brava», which also produces the company DKS.We consider in this paper, how to install a power outlet.

outlet connection Height

If you need to replace the existing outlet to a new, used the same place, onlya new device is installed.But when the initial setting is necessary to solve a number of other issues.First, choose the most suitable place.Second, decide what will be the height of the outlet unit (see. Photo).Usually it is 30 cm from the floor for the sockets and switches to 90 cm.When it is decided where you have to put the socket, begin to mount Escutcheon.

Installation Escutcheon

Enclosures differ depending on the wall material.There are options for plasterboard and concrete.Therefore, to decide how to install the outlet in the wall should be in accordance with the material of the walls themselves.Before you mount the Escutcheon, you must bring a cable with wires, it should come out of Stroebe directly to the outlet level.

If the installation is carried out in the drywall, it is necessary to put the details of the first time, if it does not work, will need to make another hole.Mounting Escutcheon in drywall is conducted on the principle of "Butterfly", so the diameter of the slot may be greater than the diameter of the frame for wall mounting is literally a couple of millimeters.But in the concrete wall of the hole can be any size, the main thing - to drown podrozetnik 1 cm And this detail is attached in the usual solution, such as alabaster..In any case, it is necessary to make sure that the length of the wires coming out of the Escutcheon, was sufficient.

mounting socket outlet

Consider setting the example outlet «Brava».

Before you follow the tips that gives step by step instructions, it is necessary to deal with the socket device.Each outlet «Brava» has three component parts:

• inner housing;
• decorative outer part;
• terminals.

inner housing is needed to fix the terminal, its mechanisms provide an opportunity to consolidate the entire device in the Escutcheon.In the photo you can see how the power is connected.It's simple: a single wire is attached to one terminal (phase) and the other wire - the second (zero).If you are planning a grounded, three-wire cable is required.Then, the third wire (usually yellow, green or striped) is connected to a hole in the middle.To avoid mistakes, you can remember what color the wire, where the land, while the grounding cable on the counter.

collected socket is secured with screws, if provided by the screw connection, the spacer legs - in the absence of screw fastening.It remains to attach the outer trim frame.

These simple steps will allow you to enable secure and reliable access to electricity.

Source: remont.dkc.ru