The ceiling of plasterboard with their hands

Installing ceiling plasterboard with their hands in two stages.In the first step, first mounted skeleton, and then performed headlining plasterboard.Let us consider more specifically at each stage.

frame Mounting

Many wonder, how to make plasterboard with their hands .For fixing profile on the starting line the perimeter of the room is carried out.Line mark with a laser level.The points marked in each of the corners.the reference line is drawn at a distance of not more than 200 mm from the main ceiling.This gap is intended to accommodate the communications and wiring.

Through the attached starting profiles.They are fastened with dowels.Between the dowels should be no more than 45 cm. The initial anchor should be mounted within 10 cm from the edge of the profile.For supporting rails and install the hangers at the base of the ceiling is carried markings.Then lines are applied to the ceiling at a distance of 1.25 m from each other.This is just half the length of a standard sheet of drywall.The framework must be designed in such a way that both the edge and the middle of the sheet of drywall is necessary on the frame edges.

on marked lines placed hangers.The value depends on the suspensions of the room.For fastening anchors used suspensions having a size of 40 mm.Starter guide should have some play relative to the base of the ceiling.Clearance should be about 3 mm.The framework itself is attached to the suspension using self-tapping kids.At work to constantly inspect the frame horizontally.The deviation can not exceed the thousandth part, in other words per meter of not more than 1 mm.The ceiling may be what is called a story.Therefore it is necessary to leave clearance on all sides.

longitudinal profiles are needed when installing the frame to make it more rigid.The profile itself is easily cut with scissors for metal, so there is no sense to pre-prepare the blank.The profile can be cut at the place of attachment.Typically, longitudinal stiffening ribs should be located at a distance of 40-60 cm from each other.If there is a need for additional noise and heat insulation between the base frame and the ceiling is placed mineral wool.

When fixing plasterboard to the established framework is important to adjust the sheets to each other as closely as possible.This will greatly simplify the carrying out of the final work.Caulking, putty them - a very important stage.Before installing drywall sheets directly on the inside of the frame must be primed.This is to ensure waterproofing.Once you fasten drywall sheets on a skeleton sheets should conduct primer.This operation is necessary to prepare the surface for paint or putty.You need to provide a small gap (in some places) to the air in the room between the sheets of plasterboard.

Headlining

How sheathe plasterboard ceiling with his hands?The first plasterboard sheets are beginning to mount on the wall, as you can see in the photo and video .Carry out fixing by means of special self-tapping screws for metal.Between the screws should be provided for a distance of about 15 cm. Spun metiz should be such that the cap is deepened by 2-3 mm.Then, these places can zashpatlevat.

ceilings Finishing plasterboard with their hands, as we can see on the video instructions below are not too complicated operation.The joints are sealed, and the heads of flooding places overwritten.In some places it is possible to use the reinforcing tape.As a result, you get a beautiful plasterboard ceilings as in the photo.

Video installation ceiling of plasterboard with their hands

Photo ceiling of plasterboard with their hands