Build Daily

Construction Site

August 12, 2017 18:06

Close up a crack in the ceiling in the home

click fraud protection
Close up a crack in the ceiling in the home

often happens that the owner of the apartment before the question arises: how to seal cracks in the ceiling, to restore his original appearance?

detachment of plaster and cracks in the ceiling of plasterboard can be produced for different reasons.

Without going into many thoughts you can just cover up the crack filler.

However, this should be done after pre-treatment and the use of quality materials.

And first of all necessary to determine the reasons due to which cracks appeared on the ceiling.After that should eliminate them and bring the ceiling in order.

For this it is necessary to perform routine repairs.

Contents:

  • Causes of cracks
  • technology to eliminate cracks
    • Masking defects
    • Local putty
    • repair deep cracks
    • Repair ceiling drywall
  • General rules

Causes cracks

Long experience has shown that defects in the ceiling appear even in the new house a month or two after the settlement.

It is well known that the defects on the surface appear even in the case when at the finishing works were used quality materials and strictly adhered to technological requirements.

The most common causes of the gap are as follows:

  • shrinkage at home;
  • sudden changes in temperature;
  • failure to snip the construction and finishing.

Cracks on plasterboard ceilings may appear between the slabs of drywall.And in this case, the cause may be incorrect installation of the suspended ceiling.

A crack in the ceiling

In order to avoid the appearance of cracks in the ceiling, you need to properly prepare for the finish and perform quality work.

  1. The rules are simple, clear and easy to run:
  2. plaster is applied to clean and dry surface;
  3. filler is selected on the basis of plaster;
  4. strength for the finishing layer is applied reinforcing mesh.

Under these conditions the obvious, the owner of the apartment does not have to subsequently wonder how to remove cracks in the ceiling.

In the case where there is a need to get rid of any defects, sealing cracks in the ceiling should be performed according to known regulations.

technology to eliminate cracks

Today at the disposal of masters finishers has a large range of possibilities to seal the cracks formed on the ceiling.

Choosing a particular technology depends on the specific conditions and sealing of cracks in the ceiling requires a thoughtful approach.

Cracks in the ceiling

If the crack has appeared between the slabs of drywall, then gloss over it useless filler.In this case, will have to do more large-scale renovation of the ceiling.

In another satisfied seal small cracks and shallow.They can be filled, or disguise.For sealing of deep lesions need to use more labor-intensive methods.

Masking defects

Pasting the ceiling slabs of foam currently used very often.This is due to the high technological properties of this material, a wide variety of colors and textures.

important to emphasize that the cost of such tiles you can use it in the most modest budget.

It can be easy to stick with their own hands, without recourse to the professionals, and to close up any gap.

At the same time, certain rules for the repair must be followed.The first thing you want to calculate the size and number of tiles.

preferred to carry out these calculations on paper, draw a plan to scale the ceiling.

After completing calculations we can go to the store building materials.

From practice repairs known that the tiles in the stickers have to be cut into specific parts.Given this fact, you need to buy it with a margin of 20%.

ceiling tile must be placed so that the joints between two adjacent tiles do not coincide with the place of finding cracks.

If this point is not taken into account, then later on the joints, with a high probability the tile corners will come unstuck.

When the sticker is necessary to observe the requirements of SNIP.This means that the ceiling surface should be thoroughly cleaned and degreased.Only then applied glue to fix the tile.

Video:

Local putty

small in size and not very deep cracks are sealed with a simple putty.In this case no overwrite the entire ceiling plane.

repairs carried out only at the place where the crack.At the same time all the required operations to perform in strict sequence.

First you need to clean up the crack of dirt, dust and crumbling of the particles.To do this, use a brush with stiff bristles.You can with metal bristles.

After cleaning the surface thoroughly crack Deep penetration composition.

primer should be thoroughly dry.

next step is to fill in the crack filler.Make sure the entire depth.You can do this in two steps.

After the final filling coat is not hardened embedded surface to align.

about a day, when the train finally solidifies, the resulting surface protecting sandpaper.

spackling cracks

a result of such termination traces of the cracks in the ceiling should not stay.However, very often repaired place and the rest of the ceiling surface of a different color.

When in the future we plan to paste over the ceiling tiles, it is not scary.If the ceiling is covered with paint, the embedded portion will have to paint several times.

repair deep cracks

When the ceiling there is a deep and extensive crack, patch up her harder.Such cracks are formed in the old tenement houses in the gap between the concrete floor slabs.

mixture, which were sealed bulkhead joints, dry, "an old woman" and fell out.In this case, for the repair, you can use the old-fashioned method.

Eliminating the gap is made using fabrics and PVA glue.The fabric is a filler and the adhesive binder composition.

work should be done by a known procedure.

to seal the gap, the inner cavity should be thoroughly cleaned and caulked with strips of cloth, pre-impregnated with glue.

on the surface of the removal of defects need to stick the fabric segment and putty.With minimal skill, this procedure is easily performed with his own hands.

Today we can patch up this crack special sealant.It is only important to choose the composition of the sealant.

The gap is filled with a mixture of several techniques.After filling out the need to collect all the excess from the surface and carefully smooth.

To permanently align and grind repaired place, need to wait until the sealant has cured.

It will take some period of time that is specified in the instructions for use.

Crack sealant

Repair ceiling drywall

cracks, cavities and other defects in the ceiling of plasterboard very often arise due to water leaks from the top floor.

But before starting repairs, you need to find out exactly the reason why the violation occurred drywall.

If gaps are the result of the overall ceiling of the deformation, then gloss over them makes no sense.It is necessary to repair the entire ceiling, and it is better to do all over again.

ceiling When not corrupted, the repaired crack, depending on its size, can be by conventional techniques.Thus it is desirable to select a filler based on gypsum.

Video:

General rules

appearance of defects in the ceiling occur for many reasons.In this case, we should not draw hasty conclusions, and immediately begin to repair quickly to seal the crack.

First we need to determine the cause of the defect.It is possible that the neighborhood is being built multi-storey building, and ground vibration caused divergence plates.

We must wait for the end of construction, and then carry out a thorough examination of the place where there was a crack.Terminate the

any crack easy.As a rule, the entire procedure is performed in-house.The main thing in this case - to remove the cause and to prevent its occurrence again.

instagram viewer