The fence on screw piles

Strong support for the protection of the site - a guarantee of quality installation of any fence.The use of screw piles reliable allows you to work quickly and to achieve excellent results.Independently make a fence on screw piles will not be difficult even inexperienced homeowner.Contractor is required only to prepare the right amount of materials and find a mate.

Materials

The qualitypurchased materials depends on the reliability of erected fencing.Therefore, when selecting bearings need to consider the impact of wind power, a lot of steel sheet itself.Particular attention should be paid to the parameters specified products, metal thickness.For the executor will need:

• combined fence screw piles (are smaller blade) with a wall thickness of about 3.5 mm;
• guides to the decking with the parameters of 4x2 cm;
• large piles with dimensions of 10x10 cm to install the gate;
• profiled with a metal thickness of 0.5 mm.

Having bought the right amount of material can be ready to go.The complete assembly of the fence on screw piles with their hands to hold simple, but the executor will need help: one mounted screw piles impossible.One builder should hold and "regulate" the support and the other two have to twist it into the ground.

Step by step instructions for installation of the fence on screw piles

Setting combined pile is made using a special nozzle.It has a square profile, two handles are used to support the rotation.Before their installation should be carried out site layout.

distance between piles should be about 2.5 m. Deepening supports held at 1.5 meters.After the workpiece supports the installation of the fence of corrugated board on screw piles is performed on such instructions:

1. On stilts marked places welding rails (at the level).The optimal distance from the ground to the bottom of 30-40 cm is considered to be the guide.

2. Held three continuous welding rail.

3. All metal parts and weld stained with primer to protect against corrosion.

4. Running screwing sheeting to guides.Fixing is carried out with the help of roofing screws.The distance between the fixings may be on the order of 10-15 cm. The sheets are joined overlapping trapezoidal sheet, at least one "wave".

Following the described work the construction of the fence on screw piles will be fully completed.Artist can also install and gate of corrugated board, and sliding doors.For the installation of the gate is required to weld a frame to hold the frame mounting on previously harvested piles.On the auxiliary photo attached to the article, it is clear that the work does not require much effort.Pre-reaching plans and calculating the required amount of material can be carried out budgetary improvement own site.Such simple fences to testify on screw pillars can not only improve safety, but carefully hide the courtyard in front of the house from prying eyes.

nuances of

Contractor necessary to accurately mark the place of installation of piles for robust design.In addition, should take into account the accuracy of welding rails.They should be placed, and above and below, and center.This will give the basis of sufficient strength and stability.It should be remembered, and the distance between the guides, leave a sufficient gap from the bottom rail to the ground.Slightly abutment sheeting to the ground is not recommended: this "neighborhood" can cause rapid deterioration of the material and the need to replace it.

Additionally, the accompanying video describes how to install sliding gate.For their installation will require a pair of short screw piles, welded to channel him.Next to u welded rollers, which will move the canvas.The next stage is the mount welded trapezoidal design: it is set in the future trapezoidal sheet.A total of two or three artists all work on the installation of the fence on screw piles will take about 1 week.

Videos fence construction on screw piles