Adjusting the plastic windows with their hands - all services

Although plastic windows and are very reliable devices, but also for them sometimes an adjustment is required, and sometimes the replacement of the hardware that is worn or broken.Causes damage can be quite different.This can be caused by shrinkage of the house, mounting defects or improper use.It often happens that in the window clearance falls debris that prevents the correct opening or closing, or dry lubrication of moving parts.Today we talk about plastic windows adjustment and maintenance, and make sure that it is quite possible to do with their hands, without the involvement of specialists.

Regular maintenance

To save the window construction performance is necessary to make it a regular service.The only and the main work that must be done at least once in six months - a lubrication of all moving parts.Apply it should be just the engine oil.

In that case, when you visually notice any flaws, some of which you will always be able to correct yourself, do not even invited to the wizard.To carry out such work you should always be on hand socket wrench 4 mm (hex).

subsidence sash

If you notice that the opening sash several dropped, you should remove the protective caps from the suspension loops and using a socket wrench, pull your hidden under the cap screws, rotating them clockwise.If you rotate the screws in the hinges counter clockwise, then drops the frame.

Seized

handle If the handle is turned not to the end, with difficulty, or if it is completely jammed, the reason for this failure may be to dry lubrication or sagging sash.First of all, it is necessary to lubricate all moving elements.If that was not enough, you need to inspect the response of clamping frames to the frame and determine where in the movable sash clip is most noticeable produces strain on strikers.

If the highest strain is on the bottom mounting plate, the flap should be slightly lifted.To do this, insert the Allen key in the bottom hinge and turn it clockwise.If the greatest deformation is noticeable in the upper corner, it is necessary to look at the upper hinge screw which biases flap in the horizontal plane.

crack on the handle or the need to replace

limiter replacement or installation of these elements is made extremely easy and quick.To replace the handle, you must turn 90 ° mounting plate it that will allow access to the mounting screws.Unscrewing the screws, you can easily take off the handle, and in its place a new set, which can be purchased in the store.If you want to install the ventilation control plate, then it should be placed under the base element attachment handle.

In order to increase the service life of handles or completely avoid damage, it is necessary to check their attachment during lubrication.handle mechanism is quite sensitive, and while manipulating a partial unscrewing screws, thus appears loose, dangling handles, which can lead to complete seizure.Regular checking of the tightening screws fixing can be an effective measure to prevent the release handle down.

Poor abutting flaps to

frame to restore the integrity and good abutting sash to the frame to perform the setup eccentric turning.For this purpose it is necessary to use an Allen key, inserting it in the feedback plate.Rotating the key causes a displacement of the movable member inside the frame.The direction of rotation is intuitive each window.Before you start to rotate the cams, it is necessary to pay attention to a point located on the edge of the roller.The closer this point would be the seal, the more powerful will be the pressing of a shutter.

If detected a serious malfunction

If faults are more significant if the windows water flows on the slopes formed by the mold, if you notice some rough editing errors or if simply you can not do what is writtenabove, feel free to contact a specialist.