Thermal insulation of a frame house : easier design - more options

Why frame houses warmest?

Recently in our country frame housing is experiencing a rebirth.This is understandable, since this type of houses as compared to other relatively heavy, which allows the use of lightweight pier foundation.

simplicity and ease of construction of the individual elements do not require special equipment.But the newly built house is good only for countries with a temperate climate, where even in winter the temperature does not drop below zero.We also need to create a multi-layer insulation system.

Warming of such houses has its own specificity.With the ability to install a larger percentage of the insulation in the construction of walls with respect to other types of homes, "karkasniki" warmed up much faster, require a smaller consumption of fuel and the temperature is well kept dialed.

Thermal insulation foam frame house and not only - select material

ways to improve frame house two: inner and outer .Of the large number of heaters are the basic foam, mineral wool and gaining momentum ecowool.Consider their features.

Warming frame house inside ecowool very promising, but due to the nature of the material, which is a loose substance, for proper installation which requires special equipment and trained staff, working with his hands not produce.

Styrofoam is the cheapest and most convenient option in terms of technology.But this active material is not environmentally friendly and does not meet fire safety standards.The use of mineral wool solve problems specific to the foam, but it is more expensive and harder to installation.

To produce insulation either of two ways, you will need the following set of tools: screwdriver, knife, stapler.

Step by step we are moving towards increased comfort

& gt; In order to start using stapler to the inside of the studs are targeting staple insulation film.Skips pairs surface of the film should be turned to us, preventing moisture penetration from the premises later in the filler.

Next start between the studs to style material which will not fall film attached inside us.If the thickness of the sheet is less than the width of the rack, then place it layers, the next layer must be offset joint space compared to the previous order to reduce heat loss.

To fix the heater in the openings in the inner surface of the rack screwed screws (Rack better than they have in a staggered manner with respect to the self-tapping screws into the second opening hours).It is desirable that they were as close as possible to the outer surface, with their help, "snake" stretched twine holding the material in the doorway.

When using the foam need to score all the gaps formed by means of foam.Then, the outside of the frame uprights are screwed screws chipboard, which in turn is being targeted windshield film.Over her long screws through the chipboard rack rails are bolted 2-4cm thick, which are facing frame coverings (siding, block-house, etc.).

Reiki needed to create the ventilation gap, which will not be collected moisture between the windscreen and the facing material.

Features external insulation home

frame house in the end result should be a "cake", but quite comfortable.Therefore, in addition to internal and external insulation made.Made it in the following way: at the beginning of the outside of the frame screwed chipboard, which is attached vapor barrier film.It will be a kind of basis on which consolidates our entire system.

top of her crate needs to be done, which is fixed with screws to the posts.After laying the sheets close it windproof film and then attach it with screws through the rail counter-battens to the frame heater on and fastened to the outer surface finish.After all the operations, all of this can be covered with a special plaster, which will contribute to stability of the temperature inside.