Learn how to put the mosaic tiles with their hands

How to lay mosaic tile - Getting Started

Perhaps it will be a repetition of truths, but still, the first step to facing the wall is its preparation.In other words, even if you're bursting with inspiration, it has to start with a routine cleaning of the surface from dust and any other contaminants.If necessary, it is desirable and degreased with a detergent.Then, when everything is ready, we determine the roughness level of the wall, as if there are significant irregularities made you laying mosaic tiles fully reflect their differences in level between the tesserae, or, as they say, chips.

always sold Mosaic modules assembled by several rows of chips, the area of ​​these blocks is in the range of 30x30 centimeters .This assembly is of two types - when the chips are fixed to the module is glued to the front of thick paper, or when they are mounted on the base of the mesh base.How to put a tile mosaic, video lessons captured the set, and everywhere it is recommended to measure everything carefully.Therefore, we must make a few modules to the wall and secure masking tape, a pencil to mark the location of the blocks relative to each other and define the area of ​​future work.strip of sufficient length and width of one meter in 1 module.

How does laying mosaic tiles?

You have two ways that can be done laying mosaic tiles with their hands, video courses that take place is entirely optional.If the tiles or glass chips are kept on the net basis, allocate enough on a site the size of a 1-module required amount of adhesive with a notched trowel, then it is possible to put a tile.In some cases, the need to pre-primed surface of the wall, but basically it is enough that it was puttied and carefully oshlifovana.Experienced masters recommend to put the glue on the back of the unit, but it is a challenge without the proper skill.

If the surface was covered tile adhesive fine glossy film, it is necessary to smear a little thin layer of glue in the same notched trowel, or tiles will not stay.

If at your disposal module with fixing paper on the front side, before laying tile, mosaic should be coated with glue.Its composition can be any, some masters prefer epoxy putty, which is grasped tightly, others prefer to work with liquid nails.Quite a few drops on the corners of the chip and one in the center.Subsequent steps are the same for any type of module - attach it to the wall, begin to smooth trowel by pressing with a little effort.If the base mesh, the adhesive must tread through it into the gaps between the chips if on paper, drops should be fully distributed by Tessera.Between blocks insert crosses the thickness of which should correspond to the distance between the chips.

few secrets, how to put mosaic tile

Once all the modules are firmly fixed on the wall, you need to thoroughly wash the surface of the chip streaks of glue that will almost certainly places available.Actually, there is no way how to put mosaic tile without contact with its front surface glue drops, if you do not use modules with a paper fixing cover. to clean the lining, you will need plenty of warm water and a sponge, one of whose surfaces has increased stiffness .When working with glass and metal mosaic tesserae is undesirable to use the sponge from the swarf, it can leave scratches clearly.

Now, gain experience in how to lay tile mosaic, video-based training can leave those who are afraid to get into practice, and themselves safely proceed to the other facing wall.All the same, you will need to wait at least 12 hours in advance of how it will be possible to fill the gaps between the chips grout.After this period, we proceed to the final operation.Because the chips are very small in size, do not worry about that almost completely cover the grout mosaic.Just carefully smooth out the composition in the joints, and then after 30 minutes you can wash the surface of the tile or glass tesserae simple little moistened sponge.