How to select and attach a plinth for a bath ?

Skirting Bathroom: species

conditionally possible to allocate a wall (border), floor and ceiling moldings in the bathroom. first mounted between the junction of the bathroom, the sink and the wall.Designed to prevent leakage of water, protection from dirt and mold behind it easy and simple to maintain.It is enough to just use the same detergents that are used to clean the bathroom.Often make it out of plastic.Only in some cases, the owners decided to install a ceramic moldings or tape-curb (self-adhesive).

decorative moldings - best or polyurethane foam.The first is a strong and flexible.Attach it can be almost any adhesives.The second very easy to mount to the surface.The only drawback is its fragility (subject to destruction under the influence of strong solvents).The floor plinth is best to choose PVC or ceramic.Both are easy to install, can withstand changes in temperature and humidity.On the whole, they are the most suitable for the bathroom.

How to glue the plinth to the bath?

To glue the plinth for a bath with his hands, a number of tools required.These include liquid nails, a knife, measuring tape, solvent and sealant gun (liquid nails), antibacterial silicone.The process begins with the fact that both should wipe all the joints and degrease them.The substrate must be clean and dry.Coming up with a tape measure the distance that will be fixed plinth.

knife cut the amount of material that is needed.There, where it is supposed docked two plinths, it is necessary to trim the edges at an angle of 45 degrees.Next antibacterial silicone-treated upper corners.Make it so that the composition is not exposed to mold.In the next step, liquid is applied to the back side of the nails.The plinth is applied to the surface.Only after some time (indicated on the package), it can be operated.

Note! If you want to have a soft and flexible moldings, then fit a special tape-curb.It also protects against moisture penetration and debris.But it is necessary to know that it does not serve long.

Plinth floor in the bathroom: a few recommendations for installation

Before buying a plinth, you must determine how much of it you need.For this measure the perimeter bathroom.This is done not difficult: the folded length and width and multiply by two.For example, the length is 5 meters, the width of 2 m.Then, the perimeter is 14 meters.Next are assessing how many profiles you need.The length of each 2.5 meters.Accordingly, the need to profile 5.6.Rounded to 6.

The next step is to proceed directly to the installation, which can be carried out using the liquid nails and using fasteners.The first option is fairly simple.On the back side of the liquid applied nails, and the baseboard is attached to the wall and the floor.The second method is considered the best, because with time the material can be easily removed.

So elaborate method of attachment.To begin, measure the desired length of plastic moldings.Do it on the layout approximate distance of 30-50 cm. At this point, the screws will be in the future.While the angle of the distance should be at least 10 cm. The last stage is applied moldings and threaded screws alternately.This installation process is finished.