Artificial stone facade - whether it is good , as natural ?

Artificial stone facade - the whole thing in an amount

state of affairs is such that if earlier, even in times of serf artisans working in stone, ornamental rocks mined huge boulders, from which one could hew whole tables or fountains, todaynatural bins languish.Find, for example, malachite vein that hewed out of it a monolithic column 2 meters in height is almost impossible.

Here also can gain artificial stone facade, which is produced as a small tile, and large arrays, the column can be formed directly during the process.Sure, in some cases, artificial stone is preferred, especially when it comes to the financial costs, because natural malachite will cost much more expensive commercial counterparts.

On the other hand, analogue has no value, but their characteristics and the use of natural stone is a sign of prosperity .You can wear in every pocket a copy of Parker pens, but the prosperous look of it will not, but only one original can make you the subject of attention.However, other times may be in analogue advantages over the original, considering the disadvantages of the latter.

Natural stone facade and cons, recorded in his copies

eternal question - better than brick facade can be resolved in two ways: a complete depletion of natural resources or the undoubted advantages of artificial materials.And the second is preferable, is not it?So let's define what we lose using natural stone facade.

example, natural stone easily crack from extremes of temperature, and the artificial has high plasticity and considerable safety margin.Further, the artificial stone is practically non-hygroscopic, ie it has moisture absorption is extremely low due to lack of pores on the surface, can not be said about the natural rocks.

If we talk about design, even on this side of natural stone is much inferior to their counterparts, colors which are much more extensive.If we consider, for example, marble, you can order a facade cladding of colors that do not exist.

And finally, the issue of repair of stone products, if used artificial, restore facing fragment will be much easier than to find a replacement to spoil the product of natural material.After all, man-made materials, whether or stone wall tiles, made by means of special forms, quickly and inexpensively.

Natural stone - it's monumental beauty

Perhaps you have already guessed that the following will be discussed on the weight of the stone, both natural and unnatural.If the facade is lined with town houses, each extra kilogram of material cost for transportation in a round sum.So it directly while working with a facing material than it is lighter, the faster the finish of the walls, the less effort is required from you.

At the end of the liner assembly building will become harder for exactly as much weighs facing material, in this case, natural stone or a copy thereof.For all these reasons, and given that the quarry where the stone is mined, it is hardly a kilometer away from your home, and the costs are proportional to the distance to it, it can be concluded that the most advantageous to use an artificial stone, which is lighter than natural.

Information, marble specific weight - 2.7 g / cm3, ie a plate with dimensions 50h50h2 centimeters will weigh no less than 13.5 kilograms, while the artificial marble weighs 2 times less.

Artificial rock in its composition has the following components: Portland cement is extremely high quality, lightweight filler material to increase strength and accelerate hardening.As you can see, the low weight of the purchased natural stone replacement not due to voids in the structure, and thanks to a special kind of filler.Some manufacturers also use silica sand as fine aggregate, but it is somewhat heavier material.In general, an artificial veneer is similar to lightweight concrete.