How to build a grinding or cutting machine from the Bulgarian ?

How best to target cutting machine from the Bulgarian?

In fact, to secure the grinders on a rigid stand, has several advantages, the main of which - freed hands.When the load during operation rests not on them, but on the stand for the tool, which does not get tired and do not tremble from exhaustion. minimized and the risk that the grinding machine from knocks hands.Regarding the situation in space, the angle at which should be fixed grinders, the options are many, are at your disposal all 360 degrees.A method of mounting the same in most models is provided - on the gear unit housing are threaded holes.

Installation grinders on the frame to be considered a tool of the electrical insulation structure, to which the installation.

However, the difference in positioning is still there, the advantage of this or that provision is, for the most part, in the comfort and safety.Also, the angle at which the tool is placed, depends on the purpose of your future machine.For example, if you want to get grinding option, it is best to fix the machine at an angle of 45 degrees, so that the locking nut is located on the top, and the bottom edge of the disc was drowned in a specially made slot.

for cutting pressed against the countertop material are two possibilities.Firstly, when Bulgarian is under the top, above the surface of which there is only the upper edge of the disc in a narrow slit.And, secondly, when the tool is clamped over the top and the edge of the disc, by contrast, is slightly recessed into the slit provided in advance.A method of mounting a horizontal grinder is quite inconvenient, because the need to work without stop, the material will be retained only by your hands.

As made bed for the Bulgarians?

If you decide to turn your sander to the machine, do not doubt the correctness of its decision.In the stationary unit will always be an advantage over the hand tool, importantly - do not neglect protection measures.But down to business.So, if we want to make the grinder, we need to make the nozzle almost entirely on the platform, designed to be placed on her material.This means that we place at an angle grinders, gear up.

To a wooden box or a side wall inclined bench bolted timber segment long enough to handle fixed to it using the grinder corner was taken out beyond the wooden base.In a drawer or countertop Scrollsaw slot drive, a short distance from her fasten hinged wooden shield, the thickness of which is to raise the grinding of the workpiece fixing tool attachment nut.

If you cause trouble makeshift bed for Bulgarians, with their hands to do it is not necessary, you can buy ready-made, in fact, the screw holes on the gear made specifically for factory racks for tools.Or you can use instead of the base own workbench.For example, you can assign a grinding machine under the table, moving through the slotted cutting disc slot.Now, even if you remove the protective shield during operation will be safe, you will close the worktop in which case from the wreckage.

Homemade machine grinder Tile

to cut artificial stone, concrete paving stones or other elements of the paving and cladding, it is necessary to use not only dry method petal diamond wheel, but also wet cutting.For this purpose, the best fit solid drive, but if you decide to use a homemade machine grinders, all of the above methods of fastening sander do not suit you.The fact that the electromechanical tools are incompatible with water.

order not to ruin an expensive unit (even if the budget, it still hurt), do a vertical basis over the top and fasten down gear grinders.Ideally, it is best to prepare two metal racks of a rectangular metal profile with welded bottom plates, which must be a minimum of 3 holes for the bolts.We carry out installation of racks on a workbench.

fastened to the support slide rails for the rollers, which are respectively Fasten to the grinder.The wheels must be oriented in opposition, that is, if the lower stand on the sled, then rest against the top from the bottom.The whole structure must be located at a height of countertops to it, or rather, in a prepared slot cutting disc has been shipped.Now, to cut off the tiles, hard enough to fix its ups and budge running grinders.