August 12, 2017 18:08
liquid foam in the cylinders is very easy, cost-effective, sound and heat insulation, long-lasting material for the construction work, but still quite simple to install.If you're using this foam does not require an additional vapor barrier.
They insulated walls, roofs and floors, and residential buildings under construction.It is made in a special unit at the construction site.It is poured into a hollow structure or into the prepared formwork.Desyatisantimetrovyh layer of this material for thermal protection replaces the foam thickness of 30 cm, mineral wool - 20 cm brickwork - 2.5 m, concrete - 2.97 m
foam bottled has the following properties:
This insulating material has the best price-quality ratio.In addition, it can be used to insulate the wall already built and it does not change the design.Also it has advantages over other heaters:
The disadvantages of this material may be considered:
Despite the large variety of modern materials, demand potting insulation foam . The great advantage is that which insulate the surface does not require training.Installation for foam production and raw materials are delivered to the construction site by car.On-site only requires access to electricity and water.
need a hose diameter of 30 mm To fill material.With it, you can pour the foam in hard to reach places.It provides high-quality dense insulation.It can also be applied to the insulated surface.
Wall insulation liquid foam can be done on any surface, and it will not affect the quality.Once the heater is useful for filling irregular geometry of the plane.
Warming houses liquid foam is produced by pouring it into the gap between the outer and inner walls.There are three ways to apply this technology to the walls.