Installation of entrance metal doors with his hands - the order & Tips

Before you decide to make this work yourself, consider that in this case all guarantee obligations of the manufacturer and the seller will automatically lose their force.But even if the door is mounted officers specialized organization, it is useful to know how and what they must do to properly install the door.

Before you begin to install the front door with your hands, you must first prepare the doorway.When an old metal door dismantled, should carefully review the released "place".Deleted should be all -.. The rest of the old nails, plaster unevenness, etc. When standing the door was metal, it is necessary as much as possible to cut the remaining part of its fastening (reinforcement bars, for example).

The door can be mounted in different ways.She or "imposed" on the doorway or recessed inside.The master itself determines how it is more convenient to put it.However, we must note that it is not recommended to put a second door way, if you have a small wall thickness, t. To. It will be easy to squeeze.For example, a jack, and that sometimes makes apartment thieves.When buying doors need to take an interest feature of the design of the door frame.

Methods door installation

In the first method, the door is attached to the mounting plate.By the way, not all models they are.Some have already been prepared for the installation is the second method.When setting assembly (door + box) on the surface of the door is a place with a wall on one line.On the plates have holes which are hammered pieces of metal rod.Can be used and the corresponding diameter anchor bolts.Thereafter them or clench or welded to the plate.The door turns the established "tight."

sequence works

• installation in the opening and locking of the box.To do this, use the wooden wedges.It should be borne in mind that between the door frame and the opening must be a certain distance (a gap);
• alignment.It begins with a "heavy" side (where the loop).Controls the position of the box plumb or level.The box should not be with a bias to one side.Also, it should not be tilt forward or backward;
• mounting box to the wall, but not tight;
• doors hanging on hinges;
• inspection and regulation of opening and closing the door.It should not touch the elements of the box;
• alignment of side plates (if needed).You should begin with that from the castle;
• final tightening of anchor bolts.

Then you need to close up any remaining gaps - the best for the job use the gun for foam.Foam not only seal all the cavities and crevices, and "glues" the surface, thereby increasing the reliability of the fixing.After her final drying (24 hours) the excess is removed, and around the door frame is made partial plastering the walls with the subsequent painting.

Needless to say that such work is not made alone.