Compressor for the aquarium with their own hands

Contents of aquarium fish is not as simple as it seems at first glance.To take full care of the fish need to create an environment as close to natural.For example, for water saturated air and constant mixing it is necessary to install a compressor.And you can do it yourself and save thus a significant amount of money.

create all the necessary conditions for aquatic life possible without the installation of additional equipment.However, the right to choose all the inhabitants and plants to create the ecological environment is difficult for non-professional aquarists and takes a considerable amount of time.Compressor installation solve these problems and can be carried out without professional assistance.

to build a compressor for aquarium with their own hands, you will need the following tools and accessories:
- small motor;
- eccentric;
- pump.

Procedure

Compressor for aquarium made in several different ways.Consider the most simple and common.

to create the compressor, proceed as follows:

1. Take a small electric motor and connect it to the power supply.It is recommended to use a motor with a voltage up to 12 volts, in the event of an extended outage, power outage left open the possibility of its powered by car battery.
2. Next on the surface of the motor is fixed eccentric by which is driven by a small pump.

Considered option is best will be appropriate in that situation, if you want to make a compressor for aquarium silent.If the presence of noise is not the main criterion for you, then you can apply to create a compressor another way:

1. As additional equipment is necessary to find an electromagnet.For example, you can use a small magnetic switch that operates at a frequency of 50 Hz from a voltage of 220 volts.
2. then need to attach to the electromagnet a small pump, the membrane which will move from side to side with a similar frequency of 50 Hz.It is thanks to this movement the pump pumps air and thus made water aeration.Unnecessary noise interference created because of work the electromagnet and for this reason this method is less common.

independent production compressor will not only be cheaper than ready-made counterparts, but can be much more effective than other devices, and it will be easier repaired.

Tips and tricks

In most cases, the aquarium is set in those areas where people reside.First of all it is necessary to take into account that the compressor should operate continuously, and so do not neglect the quality of its production.If you have built a compressor using an electromagnet, creating excessive noise, such a device can be removed in a closed cabinet.For this purpose, useful long duct.In addition, the air compressor for the aquarium can be installed in a box of old films, which will contribute to reduce the shock force.A wooden box will hide the structure from view and affect the sound insulation.

also need to know that homemade compressor tank must carry a moderate control of the air flow stream.vstraimovaemogo engine power is recommended to calculate from the formula of 0.5 l / h per liter of water.As mentioned earlier, it is desirable to put in the tank compressor with extra-low voltage (less than 12 volts).

owners fishbowl important to remember that in this type of design too powerful equipment can negatively affect fish life.Their health will be at risk due to rapid water circulation.This is an important criterion by which to fishbowl best fit low-powered device.

least of the fact that in the presence of a large number of the aquarium plants and the implementation of the oxygen supply, the use of the compressor is not necessarily in the light period.Usually in such cases, it is included only in the night time, when the plants release oxygen and stop on a par with nachinaeyut fish consumption.To disconnect the device when the water is not poured into the compressor due to the reverse thrust, must be installed on the phone, walking towards the sprayer, check valve.

compressor placement in the aquarium

After producing a compressor is necessary to fix it in the aquarium correctly.This procedure is quite easy and can be performed independently.Before installing the immediate kindly requested to choose a place where there will be a device.The compressor can be placed either above the water surface, or in a small enclosed space next to the aquarium.

sprays and hoses is recommended to fix the bottom with the help of a heavy object (a large shell or stone).In that case, the nebulizer can if fish out upwards, the water will suck the bad air.Hoses connected to the compressor should be selected from elastic rubber or silicone.If part of being in the water hose is solidified, it must be replaced.It is very important that for the normal life of inhabitants of the aquarium should be used only special hoses are designed for aquarium.

sprays may be needed only to reduce the number of bubbles.This element can personally build of special stones.The number of stones is entirely dependent on the depth of the installation spray.Check whether there is enough oxygen to fish in the water, you can observe their behavior.Most aquarium fish species prefer to move near the bottom or in the middle of an expanse of water.If all the inhabitants of the aquarium periodically rise to the surface to swallow oxygen, then necessarily need to revise the design of the compressor.