Glue for PVC panels - what to use and how to make installation ?

basic requirements for material

Before sticking PVC panel, stop on the requirements for finishing materials.This is very important because it is the place where you plan to use the trim panels may simply not be appropriate as it would not meet the requirements.Besides, if this happens, you will suffer great losses due to the damage of the material.So there you go:

• forbidden to use PVC panels in places where temperature fluctuations reach 20 degrees Celsius.
• If the temperature in the room rate, which will be used the material does not rise above 10 degrees with a minus sign, the use of panels is not recommended.
• If the finishing material was in a room where the temperature was -10 ° C, then for a while it should be placed in the room where the panels will be used.

Attention!It is recommended to lay the material over a frame of wood, so you can put it under the insulation materials or sound absorbers.

• In case panels are mounted horizontally, connecting the groove must face down.This will prevent the ingress of moisture and condensation under the material.
• Making packing material, make sure that the top and bottom were gaps 5-10 mm.
• If the installation of panels made with a pattern, you should start with a left corner and go to the right.If the material is monophonic, the starting side is not important.
• during the cutting panel size using a saw with fine pitch teeth.You can also use a special range of grinders.

Now that you know the basic principles of working with the material, you can start gathering the necessary tools to installation of PVC panels on the glue held without interruption, so to speak, from the production.

Putting tool and buy the necessary material

So, to start bonding PVC panels, you must first prepare the necessary tool for the job.Here is a sample list:

• you gon need help to cut off angles.
• not do without the building level.
• Stock up on tape.
• Using the miter box you have to cut corners on different surfaces of the panels.This is the case if you are planning to create a unique pattern on the wall or ceiling surface.

Tip!If you do not have in stock ladder, it is quite possible to manage ordinary stool or chair.Of course, if you have a standard height of the room.

In principle, dealt with the instruments.Now you have to hike in a specialty store or on the construction market.There you need to buy:

• Just do PVC panels.

Tip!Purchased material with a little stock, so you do not spend time on the selection of colors!

• angles are internal and external.
• Profiles starting.
• Cappings floor and ceiling.Meters will depend on the area of ​​your workpiece.
• adhesive panels.

All.Now you can proceed directly to the installation work.

installation PVC panels on the glue - the subtleties

process Attention!To carry out venture, you must have a perfectly flat surface.

if any, meets the requirements, then we propose to consider all the subtleties of installation:

• Before happen sticker PVC panels, you need to degrease the surface to which the material to be glued as well as the part of the panel, which will be suffered adhesive mortar.To do this, simply dissolve in water, dishwashing detergent and wipe them surface.Waiting for them to completely dry, proceed to the next step.
• Now you need to decide on the composition of the adhesive for the job.As it can be a moment of -Installation , Titan or conventional liquid nails.

Important!Depending on the chosen solution, you may need a special glue gun.

• Gluing takes place by a point.The distance between the points should vary between 30-35 cm. When everything is done, you need to press tightly against the surface of the panel.Next, attention, disconnect it and gives the order to stand 1 minute.Then again firmly pressed to the surface finishing material.The algorithm is repeated for each subsequent panel.