Useful information about the installation of the burner with your hands : the safe arrangement of the roof

rules create a gas burner with their hands

Knowing the components of the gas burner can be guided by the scheme to create your own torch.As a wooden or plastic handle take a pen used, damaged soldering device.Gas pipe should have a diameter of 0.1 centimeters and 0.2 centimeters thick.Material - steel.Tube is inserted into the handle and anchoring adhesive.The metal frame of the burner is made independently of a brass material.Diameter - 0.2 cm.In the frame drill holes for the passage of oxygen.These holes - 0.05 centimeters in diameter.Additionally, We perform another 4 holes for the passage of gas (0.01 cm diameter).The inner container (flange) is placed in a metal frame with a small open space.Get slit conducive to reduce the gas stream passing through the pilot holes.

Construction burner with their hands

injector nozzle - burner element, made of steel.A popular question is how to create an opening in a thin nozzle alone, the answer is - very simply.

1. necessary to take Sverlova tool packed in 0.2 centimeters, it can make a hole
2. The hole should be at a distance of 0.15 cm in the edge
3. Jumper is created with a diameter of 0.04 centimeters
4. Made rounded opening"clog" the hammer
5. Hole sharpen sandpaper to the desired section
6. Edge tube gear cover with a hose.We fix it
7. set the required gas flow.Turn on the gas, it has to displace the air from the hose
8. Configure end, setting the burner flame on average 5-6 centimeters.The gas burner must have a flame without smoke

Important note: Due to the proper management of the carcass turn on the injector thread can eliminate unpleasant smoke from the flames.Too spacious strengthening thread should be sealed strip FUM.

How to use the gas burner at the roof of the roof with roofing material?

Initially, you must take care of the preparatory stages of the roof the roof.It is important to eliminate unnecessary waste or pollution with additional surface coatings.When deploying a roof with roofing felt his lap 80-85 centimeters.It is necessary to fix the edges from one side to the roof perimeter, wrap the roll in the original form.

Heat the base of the roof.Gradually increase the temperature of the inner layer of roofing material.Presses the roofing to the roof special construction roller.It is important to monitor the absence of harmful air formations on the roofing material or wrinkling.

Particular attention should be paid to the roof-lap.Stacking roofing material, the edges of the hook and lift the building heated gas burner.This method provides a roof leaks.

Note: warming up roofing gas burner with their hands should be at - at least 15 degrees.

detailed introduction to the process of using the torch on the video in the next tab: