Installing the acrylic liner in the bath

old bath often violates design sophistication bathrooms and require complete replacement.Painting or applying a new layer of enamel in such a case will not completely get rid of the ugliness of the product and buy a new model requires a significant investment of funds.The optimal solution would be the installation of acrylic liner.

Buy insertion of acrylic should be based on, and set the bath parameters, itsform.Purchased product must be of high quality and durability, to avoid problems with the operation in the future.With the right product selection and proper preparation for the upgrade process will take about 2 hours.Besides installing the acrylic liner in the bath does not require special skills and be able to carry out installation of any performer.

procedure for preparing the bath

For reliable abutment of the old bath to the liner must be cleaned from the edges of adjacent plinths.

need to be cleaned carefully to avoid damaging the product, do not leave on the perimeter of the grooves on the enamel.The space around the bathroom should be completely exempt, so the old screen also must be removed.

most difficult step will be the preparation of the removal of the old drain / overflow systems.

acrylic liner for adjusting its pre-installation is required to cut the side bolsters (transport bead).

At work it is necessary to try to insert acrylic bathtub available.Special attention is given to cutting holes for the harness they should ideally be the same size and location of the holes on the old tub.

for robust and reliable installation of a new drain and overflow required immediately to hold the assembly system using a sealant.

Professional photos help properly conduct this step and eliminate the protrusion of binding the composition on the joints binding.

Step by step instructions for installing acrylic liner

installation begins acrylic liner in the bath with his hands to attach the siphon to a centralized drainage system.By tying the bathroom is laid out and fed to the previously released holes.Further work is being done according to the following algorithm:

1. In order to avoid problems with the water flowing between the insert and the bathroom need to spend applying sealant around the holes.

2. On the surface of the bath, it is applied to the sides of the two-component polyurethane foam.

3. Inside bath acrylic liner is inserted tightly pressed against the base.

4. On the established insert mounted grid drain and overflow.

5. The hole is closed and the drain to dial a full bath of cold water: this procedure will allow the liner firmly "sit" on the mounting foam.

6. Held assembly of plastic baseboards around the perimeter of the insert and closing of joints using a sealant.

7. Removed debris, and she acrylic insert purified from the pollution produced during installation.

At this stage, the installation of acrylic inserts in the bath will be completed and the owner will need to wait for complete hardening compositions.setting time depends on the characteristics of the binder mixture.Typically the process of drying it takes about 30 minutes or 1 hour.So soon after the installation of protective skirtings and clean liner households will be able to enjoy water treatments in an updated bathroom.

recommended further familiarize themselves with the supplied video before carrying out the work described.Learning the nuances of installation performed by specialists, will help eliminate problems in the preparation of the liner, install piping and the subsequent installation of acrylic lining the bathroom.Following the requirements of accuracy and performance will ensure the quality of renovation of the old baths, and improve interior room.

Video installation acrylic liner in the bath with his hands