Wiring diagram of the washing machine to the water drain

Connecting to networks overflow

connection setup to a sewage network - it is not always easy as it might seem at the outset.This can be done either on a temporary basis, or to a stationary connection.Temporary scheme have such rules:

• The discharge pipe must be connected to the discharge hose.
• should be fixed on the sides of the sink or tub.

For fixed connection used such methods:

• hose length may be different, but its basic meaning is bound to be a permitted size.Most often about such characteristics described in the attached instructions.
• necessary to use drainage siphon with non-return valves that connect to drain properly.This design is necessary for not getting dirty drain.

In some moments connected hose must be longer but you must remember that it all comes from the power of your pump unit.That is, based on this, all instructions on connecting, written specifications length sleeves.

hose connection must be at a height of 80 cm to the rear of the unit and the other end to the overflow networks.For example, a kitchen or bath through a siphon, which has a bending hose.It is recommended to make the air gap, so that when the installation has not been a system failure.Shameful height must be above the level of lifting water to avoid flooding the room.

Connecting to water supply networks

Wiring diagram of the washing machine to the water drain has been considered previously, is now desirable to consider how to connect to the water supply networks.The establishment can occur via insertion into a pipe.The length of the hose can be increased if necessary.To make such a connection, you must:

1. done plunging in cold pipeline.This method is considered the best, for it will need to cut off the water in the riser and the cause of special persons for assembly.
2. valve must be installed, which will cover the water after each washing process.
3. sure to design a protective filter, which comes after the valve.With the help of the machine will be less contaminated with all sorts of unnecessary particles.It must be periodically cleaned of dirt, as well as it is presented in the form of a mesh.

Installing faucet for washing machine

This unit can be connected to the water supply networks connecting subsea hose to the drain cock bath or sink.This will require a long pipe, through which one part to join to the crane.This method takes a little time for the connection, as well as a guarantee in the absence of flow machines.

very large number of washing machines has system * Aqua-stop *, through which the water does not get in the shutdown of the unit.In such a system, a hose has at its ends in the presence of the electromagnetic valve.Compound they have wires which control and it has to be wrapped flexible casing.If the machine is turned off, the valve is closed and the water supply is not received.

Connecting to power grids

to electrical connection is successful, it is necessary to perform this step by step guide:

• establishment of three pass outlet.
• necessary to establish a panel for the distribution of zero or ground bus.
• Isolation grounded bus.
• If the unit has a short cable, an adapter is required, as with the ground.
• grounded cable will never connect to the pipeline systems, water supply and heating.

Some apartments are sockets for electric cookers.These sockets have already been grounded, and it is easy possible to connect the washing machine.The most correct installation connection to the power grid is still the acquisition of the three-phase socket, which is held from the panel.

cable placement can both hide behind the wall, and do outside.A guard must have a current 15-30 Amperes and the underwater cable must have individual machine system.It is recommended to contact the experts, if there is no skill or special training for working with electricity.