Build Daily

Building Materials

August 12, 2017 18:08

How to glue vinyl wallpaper - capricious , but an attractive material

click fraud protection

glue vinyl wallpaper begins with a personal acquaintance

If you do not know how to do taping wall vinyl wallpaper, now we will talk about it.First of all, you need to read the instructions, embedded inside the roll.There is a brief description.By buying directly purchase the necessary glue for these cases.

When looking at the wallpaper, you will see that the web consists of two layers.The bottom layer of paper (or nonwoven fabric), and the upper - of foamed PVC.During operation, the surface well to clean and resists any mechanical stress.The top layer is usually patterned or embossed.Vinyl wallpaper glue also varies depending on the type of the lower layer, but this later.

Before correctly pokleit vinyl wallpaper, you need to ...

Before pokleit vinyl wallpaper, pre purchase necessary tools: roller glue, knife, tape measure, scissors, pencil, brush or rubber rollerfor smoothing, as a spatula categorically do not accept, it will knock all embossed vinyl surface.

walls must be carefully prepared

, they must be cleaned of old finishing material residues, remove existing paint and whitewash.Then treat the walls fungicidal composition against fungi.Once this structure is dry, draw a vertical line on the wall, check its location when using the level.Then prepare the adhesive in accordance with the attached instructions.Lids of sockets and switches, remove, turn off the electricity.Make sure that the room was not draft.

technology gluing vinyl wallpaper together on one page

We now consider how to pokleit vinyl wallpaper.Cut strips of desired length, do not forget to leave an allowance of 10 cm. Make sure the correct registration motif. strips should be applied butt .Spread the wall with glue and place accurately through the first panel.It is better to work together, so it will be faster and better.One person is standing on a ladder, and the second will help to combine the bandwidth in accordance with a pattern.Then you can safely begin smoothing the sheet over the entire surface.At the same time making sure that the material does not remain under the air bubbles.It is better to start smooth from the center in opposite directions .Roller carefully rolled seams.If necessary a small brush further lubricate the joint line.The entire instruction set is well secured with video playback "as the glue vinyl wallpaper."

main factor that must be considered at this stage, not to destroy delicate circuitry, how to stick the vinyl wallpaper - this gluing.Depending from the lower layer, it is applied only on the wall or on another sheet previously.If the bottom layer - Non-woven, the pre-impregnated with them is not required if the paper - they have to be a thin layer of fluff.

Try to carefully cut the excess length from the plinth.On the bottom edge of the plinth fabric should lie flat with an overlap of 4 to 6 mm.The upper edge of the strip must also be cut off at ceiling level.Skirting is better to remove before work, but if this is not possible, the lower the cut edge of the bend perpendicular to the wall.

also subtle point is proglazhivanie.Not for nothing in the tool list is specified rubber roller, rather than a spatula, which is used in most cases finishes.It's all about the texture of the material, if you shopped for your purchase, then one of the questions is: how to stick vinyl embossed wallpaper?Any hard object or a strong push spoil the delicate structure of the surface pattern, so do not miss this point of view when working.

glue vinyl wallpaper - aftertaste

Once everything is complete, bottom glue strip, where the plinth adjacent to the wall.Pasting wallpaper on the corners, do it carefully.If the angles are uneven, you may have to make an incision in the wallpaper, so they can be good glue.Behind the wall of a radiator can also try to patch up the wallpaper or paint the paint in the appropriate color.

In those places where the sockets and switches, make oval cuts and put the previously removed caps in place by screwing cogs.At the top of the wallpaper glue fillets.

In conclusion, it should be noted that when buying you have paid attention to the serial number chosen Party wallpaper.They should all be of the same color.When will become glued wallpaper, they do not stretch and straighten the roll.Well presented sticky vinyl wallpaper in the video, try, experiment, but do not break the main rule, which requires technology gluing vinyl wallpaper.

instagram viewer