Plaster walls on beacons video, plastering technology

plastering walls make for their alignment before subsequent painting, wallpapering or tiles.To plastering the walls using a special dry mixture or a mixture of cement and sand.The consistency of the resulting plaster should be thick enough so that the mixture does not slip down the wall under its own weight.Below sure to check out the video plaster walls on beacons from the pros.

walls before work should be cleaned from the remnants of old plaster, glue, etc.It is also necessary primed wall special primers or mixtures diluted tenfold with white glue.See how to choose the best primer.A very important part is the proper exposure beacons.They used rails, plastic or wood.In order to attach them to the wall, apply the solution with a spatula for one bit line, departing from the angle of about 20 cm - 30 cm. The solution was pressed into the rail.Beacons (their outer face) must be separated from the wall by 25-35 mm.Level reconcile uprights location.

repeat the procedure from the second corner.Then, on the outside of each beacon in the lower and upper parts of the walls trying to drive on the dowels.His hat must be on par with the beacons.We stretch horizontally between the dowels cord cut, the top and bottom.According cord exhibit additional beacons.The distance between two beacons must not exceed the length of the rule.Now we need to wait a few hours to a solution of permanently seized.Plaster walls on beacons is the simplest and most common technique, respectively.

Widget from SocialMart

Immediately before the operation should wet the wall to better plaster fell on her, and wait a little, let the water soak.When operating in conditions of high humidity in the plaster, you can add a bit of alabaster.Plastering the walls only at zero temperature.If desired, for greater reliability can be mounted on a wall fine mesh, metal or synthetic materials.If the work is carried out on the sand-lime brick, the presence of the grid becomes mandatory.

can proceed directly to the plaster.Throws a spatula or your hands the solution to the wall.Further, the rule should be to align the mixture on the wall from the bottom up.Work should be without any pressure.The corners are aligned with a spatula.Do not forget to remove the beacons.Overwrites formed seams solution.Now it remains only to wait for the fact that the plaster dries completely.The surface can wipe out karbolit grater.Flow Calculator rodband plaster.

Plaster Walls video beacons

Below is good information on the works on plastering the walls from tools, surface finish, the nomination and installation of beacons, surface preparation technology plastering the walls with his own hands.

https: //

Videos from Knauf company demonstrates the whole process of how to mix stucco "Rotband", to prepare the surface of the wall, how to install beacons on the wall properly, you apply the plaster on the wall on technology.See as the same one more our article plaster walls with his own hands, there are a few video examples and more detailed article on the installation of lighthouses and other.