Build Daily

Ceiling

August 12, 2017 18:05

Stretch ceilings with their hands

click fraud protection

recently suspended ceiling is considered a sign of viability of the hosts.Today, this is no surprise, and even a man of medium level of prosperity could well afford such a "luxury."The question is not even worth that money for such repairs will be enough, but the question is in fact to do the ceilings with their hands or invite experts for this?

Content

  1. Removing measurements from the ceiling
  2. Profile Fixture
  3. Mounting racks for fixtures
  4. Installation web
  5. Video Installation of a stretch ceiling with his hands

Removing measurements from the ceiling

If the owner of the house a little versed in painting and decorating, such a question, as the installation of suspended ceilings with their hands will not be any problem for him.But in order to know how much is required of all profiles and finishing material must be removed from the measurement ceiling.

This process is considered to be one of the most difficult, as it will require measurements.If this is not done meticulously, it depends on the correct installation of the ceiling.Today it is possible to mount a single-level and two-level stretch ceiling with his hands - this should also immediately determine which option is more preferable.

All measurements should be applied on a clean sheet of paper.First measured the perimeter of the ceiling and made measurements of all possible diagonals.This process of measurement is a very important especially in the case where the multi-level ceilings are made with their own hands, as there should be to measure diagonally not only 4 corner of the room, and all the other corners.And only after all the measurements can buy all the necessary materials.

Fixture Profile

To suspended ceiling look beautiful and attractive, it is necessary to fix the profile correctly.They should be placed around the perimeter of the ceiling.But before fastening them to be on the level of trim.Also, when selecting a profile should take into account such thing: they need to pick up such a height that could loosely fit lamps.When fixing can occur only one difficulty - angular profiles docked.In these places the edge profile is cut at an angle of 45 degrees.

Fasteners racks for fixtures

Since suspended ceilings and the device assumes the installation of fixtures, it is very important to define the points where they will be.They should be placed around the perimeter of the ceiling.With mounting fixtures should be done immediately and the wiring of electrical wires to them.To know where to make cuts under the lights, with the help of a plumb line from each light must be on the floor to put the point of their location, and start the installation of the fabric.

Installation web

If installation is a stretch ceiling with his hands, then you should know that it should be a little warm up before the stretching of the web.If this is not done, then the canvas will sag.Photos and video of a stretch ceiling installation can be found in this article.It shows the process and how it is all done in order.If the ceiling is small, and besides - a multi-level, the web can be heated in the usual hairdryer.

If you look closely at the video installation of a tension ceiling it is possible to know that the web is gradually warming up, it should be fastened with the middle of the ceiling;securing one side, it is necessary to pass to the second.Pulling and attaching fabric fully, it is also warm up for about 15 minutes - after cooling it will tighten well.After reading this article, you can understand how to make the ceilings with their hands even in the apartment, even in a private home.

Video Installation of a stretch ceiling with his hands

Mounting tension ceiling with pipe Bypassed:

instagram viewer