Danish decorative plaster , the main characteristics and application

Properties Danish plaster

• ease of use and application.The plaster can be used even novice master.The principle of mixing indicated on the packaging.
• Extensive manual in any premises without restrictions.
• great appearance allows the use of plaster with any finishing materials and decor items.
• Allows you to visually align the ceilings and walls.The coating thickness may be selected independently (1 to 10 mm).
• has excellent heat and sound insulating properties due to the porous structure.
• has good moisture-absorbing ability.This is especially important in rooms with excessive humidity.For example, if you cover the ceiling in the bathroom of the plaster away the stuffiness.
• features high fire safety.When burned, it does not emit toxic substances and does not spread the fire.
• has a neutral electrical charge, that is, anti-static.This property is obtained by using only a part of the natural components (cellulose and cotton fiber).
• are practical.Due to the fact that no seams on the wall, there is no waste of the substrate.And the remainder of the material allows for reuse (for repair or elimination of defects).
• It features good air permeability, does not absorb smoke and odor.

Scope

Danish plaster otherwise known as liquid wallpaper and can be used to design almost any interior (kitchen, bathroom, toilet, living room, corridor).Also, it is often used for decoration in office and administrative buildings, schools and kindergartens, and other areas.

Danish plaster especially popular when decorating in different rooms.For example, it is often used in the decoration of museums, galleries, exhibition halls.Its textured surface provides excellent beautiful appearance.

Dosing

• To begin with prepared surface.With it removed the old wallpaper, whitewash, paint and any other cover.Also, the surface is cleaned of dirt, dust, grease and bitumen stains.
• Next on the cleaned surface is applied two coats of a good oil paint (for example, alkyd).It is necessary for a new coating of the walls were not any glue stains, varnishes, rust, etc. N.
• Then One coat of water-based paint dispersion of PVA.It is necessary for better adhesion of plaster to the surface.
• field of preparing a mixture of plaster.Package contents are poured into an enamel or plastic container.Filled with warm water (about 9.7 liters).The mixture was stirred until a uniform, viscous mass and aged for 2-3 hours (until dissolution glue), then mixed again.
• resulting mass is applied to the surface with a trowel plastic walls and wide horizontal movements required to smooth the thickness (1.2 mm).
• for surface alignment is used rough seamless foam roller, periodically wetting it with water and pressing.
• In order to obtain flat wall, you must apply the material without a long hiatus from corner to corner.Otherwise, the joints may appear between the wet and has not dried up material.
• remaining liquid composition plaster need to roll out a thin layer (dough) and dry.In the future, it can be re-used for the repair of damaged areas.