Hatch to the attic - master the self- assembly

Luc exit to the attic - the basic requirements for the results

Luc attic will allow free up additional useful area which can be used for a variety of needs: from the installation of equipment, such as ventilation, to resettlement residential attic floor.

Luc exit to the attic should be characterized by easy installation, durability and functionality, ease of use, attractive design.The cover should be well sealed and insulated, to prevent leakage of warm air masses from the premises.Stairs for this hatch is required lightweight, but strong enough to have a simple folding mechanism.

Serial the hatch to the attic with staircase, the dimensions of which are standardized and are typically 60x120 cm, in most cases equipped with a thin cover of hardboard.These hatches allow leakage of warm air, resulting in significant energy loss.If the attic space is not insulated, it would be more appropriate to make the passage to the attic in the home and take care of the insulation.

Luc attic - prepare door

first step is to determine the location of the future exit to the attic.If possible, it should be placed on the landing, but at the same time, not too close to the flight of stairs.This hole is located in the bedroom, take only inconvenience.The slope of the roof also plays a very important role, since for ease of such a withdrawal over the hatch should be enough space.

After that, you can begin to assemble the frame to exit the top.For this fit boards 30 mm in thickness.As the hatch must be compact enough, it is best to stick to the standard sizes.Frame to do the same rectangular shape with angles 90 °.

suitable fiberboard sheet, cut the size of the internal frame to manufacture insulated hatch.Fiberboard can be pasted on a sheet of expanded polystyrene, which, in turn, another sheet pasted chipboard.To seal the attic hatch on the inner perimeter of the frame to be glued sealing gum.

The resulting door is attached to the frame hinges.For convenience, you can tie to the access door handle and door latch is better equipped.For smooth opening of the hatch to the inner side of the longitudinal boards that make up the frame and to the door closers wish to attach special.

hatch to the attic - the final stage

Then you can proceed to the cutting of the opening under the loft hatch with a ladder.The size of the frame to the desired location of the hole.If possible, cut only one ceiling beam.Along the edges of the resulting cut-out is necessary to collect another frame, which is clearly marked by the opening borders hatch.

This harness is fastened to the ceiling beams with 100 mm nails, and already attached to it previously collected frame of the hatch cover.The bottom edge is required to treat damaged putty or plaster, and the frame is better to bypass trim or to give the aperture a neat appearance.

This cover can be used in conjunction with an aluminum ladder, which is sold separately, but for convenience it will be better to make a folding or retractable ladder or buy a ready-made version.In most cases, the ladder length must correspond to the height of the ceiling, although they can be used longer ladder.